EVERY bank fisherman needs one of these! (Rod Holders)

Рет қаралды 29,901

2 жыл бұрын

Sticks are also a “ok” alternative, besides they are free but they aren’t as strong, durable, or reliable and I personally just don’t trust them. Check out the links below to the rod holders talked about in this video.
www.basspro.com/shop/en/cabel...
trophycattackle.com/
trophycattackle.com/products/...
Ozark Trail 1-Position Marine Rod Holder - White www.walmart.com/ip/973416659
These ARE NOT $11.87, they are around $3
Metal Spiral Fishing Rod Holder 12'' Fishing Pole Stand Rest Rods for Ground www.walmart.com/ip/850868006
monsterrodholders.com/product...
www.lowes.com/pd/Blue-Hawk-Co...
Instagram: FishingWithChris_yt
Facebook: FishingWithChris
#fishing #creekfishing #youtube #crappie #ultralight #bankfishing #fishingvideo #fishinglife #fishingvideos #outdoors #fish #subscribe #bassfishing #fishingtips #catchandcook

Пікірлер: 35

@crbrepairmotorcycles6608

I was thinking of purchasing the bass pro model and they are sold out of the longer ones so just go to local metal welding shop and add 2ft on to the short one in stock just bolt it on if ever wanted short again just remove added piece

@haroldpruitt8207 21 күн бұрын

Thank you Ol’ buddy! Much appreciated 👍👍👍

@redneck3848

Or you can literally just drop a piece of PVC 2 inch into the ground without paying these ridiculous prices

@topnotchtrimming4546 Жыл бұрын

Why would you need a rod holder with a bait clicker?

@ohtrxppy8652 12 сағат бұрын

Why use tape

@joebuck66 2 жыл бұрын

I really like the Muddy River Holders. Being cheap, it’s hard to come up with $20 sometimes. I have made my own with a ozark trails boat rod holder welded to a piece of 3/8 round steel about two and a half to three foot long. They will work for me till I can save up to get a couple of Muddy River. Great video Chris

@williamswindle5445 2 жыл бұрын

I've built rod holders over the years to leave in place. yours with the tpost is a good idea.

@terryhancock Жыл бұрын

You can cut 1 1/2 inch pipe at a 45 degree angle

@rgrea2 Жыл бұрын

Looking till I saw and heard you mention the muddy river rod holders (Takedown Rod holders LLC) and yes that is something I would use and will get a set. Thanks for the help.

@latishajaubert5600

I was just thinking of making some just like yours with the PVC.

@texasplumr 2 жыл бұрын

I use scrap 1 1/2" angle iron. If a person doesn't have access to scrap, they can check scrap yards and they'll sell it by the pound. Lowes and Home Depot have short pieces that aren't too expensive. I then cut 2" PVC in the lengths that I need (12" to 18" is usually enough) and fasten to the inside of the angle iron with 2 hose clamps. I leave 1 or 2 inches of angle sticking above the PVC so I can drive it in with a hammer.