Evinrude ETEC Grease Maintenance / 3 Year 300 Hour Service

Рет қаралды 10,064

1Cast 1Fish

Күн бұрын

Пікірлер: 24

@YourNextCast Жыл бұрын

Appreciate how you have a whole library of content on how to care for your equipment.

@1Cast1Fish Жыл бұрын

I try my best to take care of things and keep them maintained...just sooooooo expensive to get anything fixed anymore

@omcbob37 2 ай бұрын

Both of my local Evinrude dealers have quit servicing Evinrude motors and carrying BRP parts or service items, so I've switched to Lucas Marine Grease with great results - stays in place as well as Triple Guard grease and I can also use the Lucas grease on the trailer wheel bearings.

@1Cast1Fish 2 ай бұрын

I used the Lucas on my old boat for the same reason...it was simpler to use 1 grease vs 2.

@thomasbm1 4 ай бұрын

Dont forget to add grease to your exhaust valve, have to remove lower plastic covers. Its on port side if engine. Just did on my 2014 E-tec 115 HO. Also had to replace my actuator motor but luckily the exhaust valve was not stuck due to someone else had applied grease earlier 😇

@1Cast1Fish 3 ай бұрын

Correct on the lower HP motors...the 150 does not have this.

@rcg5334 8 ай бұрын

Great tutorial! Congratulations fron Spain! 👍

@1Cast1Fish 8 ай бұрын

Thanks! 😃 Awesome to see a comment from Spain

@rcg5334 8 ай бұрын

@@1Cast1Fish yes Sir, I have got a little Evinrude E TEC 50hp and I'm learning about It seeing your videos. Thanks a lot.

@3DOutdoors Жыл бұрын

Excellent information.

@1Cast1Fish Жыл бұрын

Thanks for watching!

@trcass1 Жыл бұрын

great tutorial. appreciate the share.

@1Cast1Fish Жыл бұрын

Glad it was helpful!

@JohnAmes Жыл бұрын

some great information my friend

@1Cast1Fish Жыл бұрын

Thanks for watching

@wjstewdog 7 ай бұрын

great vid

@1Cast1Fish 7 ай бұрын

Thank You :)

@akosguzsik6935 4 ай бұрын

What grease gun do you need for the job and with what fitting ? I try to figure it out but the manuel doesn’t tell me.

@1Cast1Fish 4 ай бұрын

It is a ZERK type fitting. I used a full size grease gun with flexible hose and ZERK attachment.

@user-mq7lx9sp2o 9 ай бұрын

How does grease get to the upper bushing on the swivel bracket or steering arm assy?

@1Cast1Fish 9 ай бұрын

Not sure it's exact route, but I normally see some new grease when I am pumping in the new...so it gets there

@lorysproxton8506 2 ай бұрын

Any marine grease will work fine and cost you about a quarter as much

@1Cast1Fish 2 ай бұрын

It lasts a long time, so I have just kept with the same stuff that was original.