This video walks you through how to fixed the crushed compression mid-valve shims on the Aprilia Tuareg 660 and install a new base valve.
Пікірлер: 19
@AdventureMiles12 күн бұрын
Great walkthrough. I’m going to wait until the winter and see if the dealer will warranty mine, but otherwise I will be using your walkthrough.
@skeelo22111 күн бұрын
Nice Paul! Thanks for the walk-through. One additional note for those attempting this, before re-installing the fork cap to set the clicker screw such that you measure a 13mm gap from the bottom of the cap to the bottom of the clicker screw. Otherwise when re-installing the fork cap you won't get correct range of clicker adjustment.
@EvoOregonSuspension11 күн бұрын
That’s a good call out on setting at 13mm. I’d forgotten to shoot that step. I’ll add it in the description of the video.
@bretthawton11 күн бұрын
FYI- My service manual says the oil height is 117mm (not 90mm).
@EvoOregonSuspension11 күн бұрын
Earlier versions of the manual say 90, and from what I am told they say to set it with the spring guide out. I set to 100mm with the spring guide in on my setup. All other OC forks you set with the spring guide in. 90-100 with the guide in is very similar to other forks in this class (T7, DesertX)
@bretthawton11 күн бұрын
@EvoOregonSuspension understood. I have the most recent edition service manual. Let me know if you want me to email you the PDF pages of the that include torque settings, fluid levels, etc...
@skeelo22110 күн бұрын
@@bretthawton I'll have to try with lower oil height. I have mine set to 125mm so I'll try 100mm to see the difference. BTW I measured on my RS 660 fork which should be about the same, and 2cc = 5mm oil height. So if you want to start low it is easy to add 2cc at a time to adjust oil height in 5mm increments. Sadly these fork caps don't have a bleeder screw, as that's the easily way to do it quickly is to remove the bleeder screw and add the fluid there so you don't have to remove the fork cap.
@billcom120010 күн бұрын
@@bretthawton My manual says 90 mm. Code for the manual is 2Q000524. Is yours more recent than this?
@bretthawton10 күн бұрын
@billcom1200 mine says 2Q000524, too, on page 327. What page do you see 90mm?