Coach thanks for the free knowledge that makes our lives more valuable

Thanks a bunch coach makes me more knowledgeable and confident when I’m out there in the field.

Coach I wish you would put out more info on bonding water pipes and gas lines also here in TN - the state is asking/requiring a bonding jumper inside the panel from ground bar to ground bar is its a 4 wire and there are 2 ground bars ( like I put a bar on each side of the box ), Cost maybe $10 more but IMO it sure makes the job look better ( gooder)

Great stuff coach ❤

The confusion about panel height comes from old timer's like me. When I started in the late 1980's all service panels had a up/down configuration for the main breaker which was always on the top of the panel. So we always made sure that this breaker was not higher then 6 ft 6 then later 6 ft 7. Then in the early 2000's the horizontal main breaker panels came out so we had to rethink that. It took the old timers a while to GET IT. If you installed a panel with the main on the bottom like you said in the video top breaker knockout not higher than 6 ft 7

Thank coach. Great info. Blessings from Avenal Ca.

Very informative

Thank you for the knowledge!⚡️

Thanks 🙏 coach From Southern California fountain valley California ✌️👌

Great video, thanks. Question for you... Installing an outlet near a toilet for a bidet? What are your recommendations regarding the NEC's requirements on distance and placement. Thanks!

Your content is great Thanks

With a meter/disconnect, is the inside panel treated as a service panel or a sub-panel?

Why THHW and XHWN are in the 75°C and 90°C column in Table 310.16?

Don't you love panel schedules that are labeled evens and the breaker numbers are laid out on odds

Great detail, 👍

Thanks

greetings could you explain the question. For a feeder tap not exceeding 10 feet in length and field installation,the maximum overcurren device rating supplying a tap conductor with an ampacity of 40amps is-------? article240.21b(1) (4)

Hi