Рет қаралды 7,047
1jzgte Fuel Cut Defender Install
In this video I'll show you How To Install a HKS Fuel Cut Defender on a 1jzgte Non-Vvti. Installation will take at least 30 mins or less if you have experience. Please note I'm not liable for any damages caused to your vehicle. Do at your own risk.
This FCD i Installed has four (4) wires:
Yellow - this wire should be connected PIM (MAP) wire going towards the ecu
White- this wire should be connected on the wire coming from the harness
Red - this wire is connected to any 12volt source . i used the 12 volt that supplies the ecu
Black - this wire can be connected to any earth.
Please note that when adjusting fuel cut defender the vehicle must be off.
0:43 How a Fuel Cut Defender Works
2:10 How to Install a Fuel Cut Defender
2:50 How to Locate ECU Harness Wires to tap into (MAP signal and 12 volts supply)
5:30 Tap and join Fuel Cut Defender harness Wires to ECU harness
6:27 Test if the Installation was done correctly before mounting FCD
6:49 How to Adjust Fuel Cut
8:26 Test Drive with fuel cut defender
More information about the wiring diagram for 1jzgte can be found on the wilbo site: wilbo666.pbworks.com/w/page/47...
follow me:
Instagram: / jonnoi_flet. .
Tik Tok: @jonnoifletcher1
Hit subscribe and enjoy!!!
All rights of the music in this video belongs to their original owners.
No copyright intended.