Ye I've a few videos on the 20 afterwards If there's diesel coming out both bleed screws on the pump it should run open the injectors pipes and crank it see if there's diesel coming out

Also, is this a simple dismantle, clean and reassemble job? Is there any special resetting up that needs to be done?

@@stewartleadley34 no just with the engine off diesel should gravity flow out so should be a nice drop coming out Ye just a good clean screws can be tight so a couple taps on the screwdriver with a hammer does the job

@@stewartleadley34 no setting anything should be perfect with just a good clean and check diafram isn't split or tractor wont idle properly

Just mark the position on the pump body where it bolts on then once pump is removed Mark the rotor and don't rotate the engine it slots back in reverse of removal

@@gearsandtears7643 okay, got it. Thank you.

Hi Ethan have you cleaned the filters inside the pump?

I got the diafram online from Clifford tractor supply in Kerry Everything else was cleaned and sealed up with dirko sealant Petrol and an air line cleaned up the diesel gauzes like new then I bled the pump a good bit to make sure it was clean diesel

Everything you in one place agrilineproducts.com/ferguson/ferguson/tef20