Nice I went this way with gear setup 2005 Fatboy I got a knock at idle hot and wide open throttle, my indie says gears make noise!! I wish they tell you before you give them your bike that it's going to be a little bit louder.. coming out!! I don't care how many o-rings, shims there are, always going to have tolerance especially hot! Brand new S&S crank, fueling 8017 aluminum billet cam plate, HF oil pump, fueling lifters, and gear driven 37 G Andrew cams.

Thanks for the video. I'm about to order the Fueling hydraulic conversion and give it a go

Shit i used a ball pin hammer, sockets and lube to instal the bearings onto into my plate and onto my cam

Why not have this stuff come on the cams and charge a little more?

You didn't show the installation of the bearings into the cam chest. Do you install the bearings with the lettering face up (showing), or install the bearings with the lettering face down (going down into the cam plate)?

The o-ring setup seems really goofy. I know everyone does it, but why?

music is very distracting