Thank you, John!

Thank you, Kashyap!

Thank you!

Thanks

Thank you. I did not measure, but I did tighten it more under the car, until the center rubber tip on top of the spring did not touch the body.

Most of fiat 500 parts stores has it. I got it from passione500.

If you used the compressor tool, I think it should be at the right height immediately. I didn't notice any lowering on mine after installation. Maybe ~1cm, not really noticeable.

I did just restore my old spring. If you fit a new one, it may need some time to settle.

@@AircooledProjectYes, it will not be the same as a new one I guess.

Thank you! I got most of the parts from Axel Gerstl in Germany and a few from Passione500 in Italy. Axel is usually on the expensive side, but service is very good, fast shipping. Also check out Fdricambi, I plan on buying some parts from them also. All the new parts until now were about 3000 eur, including some non essential ones, accessories and a 123ignition electronic distributor that I didn't film. If you were asking only about the parts for the leaf spring, those are very cheap, maybe 30-40 eur from Axel Gerstl.

@@AircooledProject great thank you for the info. Did you buy those plastic things also from him?

The ones that go around the leafspring? Yes, it comes as a kit with the metal bands, it should be available in all 3 webstores I mentioned previously.

@@AircooledProject perfect will check it out. Thank you for your help, i will probably bother you some more on some other occasions.

You're welcome. No bother, happy to help.

:)) co-stars