FIAT 500 - How to replace coolant radiator / blower motor

No video

FIAT 500 - How to replace coolant radiator / blower motor - DIY

Рет қаралды 23,843

Күн бұрын

Welcome to my KZfaq channel. In this video you can find out how to replace coolant radiator/ blower motor step by step.
Music: Machine Guy - gbry.svg

Пікірлер: 17

@sushi_garage Жыл бұрын

Hope it'll help :)

@dannygameplayes6363 4 ай бұрын

It helped, ty from 🇮🇹(where this tuna can was invented

@leftshoe202 Жыл бұрын

You da man, boutta tackle this myself today. Hope it goes well!

@sushi_garage Жыл бұрын

Not a big deal. Good luck:)

@allanmanning 6 ай бұрын

Thanks. That's great help. 👍

@Stefanos.Tsokaras Жыл бұрын

Nice work!

@Morzsaszar Жыл бұрын

Thank you!

@lasanadrammeh1308 6 ай бұрын

Good one

@nicoledewinnaar4937 5 ай бұрын

If u need to put in stop radiator leak, do u out it in the resevoir tank as well?

@michelleb6737 4 ай бұрын

How much coolant did it take to refill the reservoir back up after being drained completely?

@storsina762 Жыл бұрын

Any other way to remove radiator fan with out having to break it all down can you remove the skid plate and reach up under it loosen screws and drop it down thru the bottom just wondering

@sushi_garage Жыл бұрын

To remove blower only you could try to unscrew this two bolts first, disconnect this two plugs and you will see if you have enough space to take it out. But personally I think it will be impossible. There is no enough space but you can always try before removing front bumper. Good luck.

@asid731 9 ай бұрын

Thank you for the video. What is the labor time on this?

@sushi_garage 9 ай бұрын

I think it's about 2 hours of work with no hurry. It's also depends on rust on bolts and nuts

@asid731 9 ай бұрын

@@sushi_garage thanks

@SFlightline 2 ай бұрын

Complete waste of time and effort... The Fan and surround can be removed with the bumper and Radiator is position... 1. Remove wiring for resistor and fan + - 12v supply 2. undo and remove two screws holding the fan in place, then slide the fan to the side to allow it to move out of the retaining tabs... 3. jack the front of the car up so the wheels are about 4 inches off the ground, then remove the fan and surround from underneath the car... Only one side of the car needs to be raised. Install new rad fan in reverse of removal. Time taken about 45 mins Max...

@sushi_garage 2 ай бұрын

Maybe, but I was replacing radiator too and you can't remove it without removing a bumper. Radiator fan was just a "milestone".