Step-by-step walkthrough of fibreglassing the inside of the 3D printed Stormtrooper helmet to add structural strength to the PLA plastic.
Пікірлер: 4
@jasononeal3 ай бұрын
Nice job... be careful cutting that chopstrand without a respirator and eye protection.
@downunderstormtrooper3 ай бұрын
Thanks for the tip
@jasononeal3 ай бұрын
@@downunderstormtrooper I see your thumbnail has a respirator, sorry if my Monday morning criticism was unfounded.
@downunderstormtrooper3 ай бұрын
All good mate. I put the respirator on before I started mixing the resin, but it would probably have been smart to wear it when cutting the sheets too.