Go buy a valve core tool from your local parts store and start with half the tool already made 😊

Very nice and clean! 👌

You are a genius

Simple et efficace 👏👍 Merci 🎉

Good idea👍

Nice videos 🎉

Gostei é simples e facil de fazer ✌️✌️✌️

Gostei deste método bem mais simples e

Could you build something like this for 12ga wire but also put a nitroset clip in the loop and use a hand drill driver?

safety first!!!! be carefull, you could do all that with stationary equipment and with safety!

❤❤❤ GRAZIE ❤️❤️❤️

Its cool to invent, create your own homemade things, but the Time, Effort, and Tools needed...., I personally Would just get an Inexpensive Wire bending loop Tool. But agree.... There is personal Satisfaction Making it yourself.

Ačiū už patarymus,,, za trudi ne gliadia laik

You could sell those. 🤘🏻

How to For wire 0.4mm

👍👍❤❤

Which wire size are you using? my loops came out awful and it might be because I'm using a softer wire (20lbs)

😮

볼트 🔩 만들수이서요?

Взял отвёртку изнахратил 😂

Very cool ideas but please if you try this use a vice or brace it on a table at least to protect your fingers when using a saw like this . I’d hate for someone to follow these instructions and have that saw skip over into their fingers .

It's a good idea, but... the 'know how' is very dangerous! É uma ótima ideia, porém a forma como fez o corte não é nada recomendável, é muito inseguro.

Как ещё пальцы целы?

А в чём проблема эту накрутку сделать с помощью тех же круглогубцев и пальцев рук ну или в крайнем случае плоскогубцев и круглогубцев

Are you actually that poor???