Fitting a DCC Decoder to Older DC Trains

Рет қаралды 6,558

4 жыл бұрын

This video shows how it is possible to fit a DCC Decoder to an older, DC Train.
Most older style DC locos can be easily converted to run on your DCC layout. Just make sure that it already runs will on DC, as converting it to DCC won't make it run any better!
Disclaimer, the conversion shown in this video is just for this motor/chassis combination. Its important to ensure that the motor is isolated from the power. Some locos have a constant feed through the wheels and chassis that can't be interrupted without slight modifications. Not isolating the motor can result in damage (terminal) to your decoder.
4 Pin Hornby Decoder
amzn.to/3jdLRgp
Heat Shrink
amzn.to/2CgkUbz
Music from Epidemic
www.epidemicsound.com/referra...

Пікірлер: 14

@JohnSmithShields 3 жыл бұрын

Thank you. I will be trying this on my 'Pullman' class 06.

@BuntersYard 3 жыл бұрын

Good luck! Let me know how you get on.

@JohnSmithShields 3 жыл бұрын

Update time. I finally attempted this. There was a small issue, my 06 was wired up a little differently. There were wires from the pickups to the motor. After taking a deep breath, I cut the wires, unsoldered the capacitors and wires from the motor and went for it. For the results, see the attached video. The slow speeds are impressive, bearing in mind how this thing moves on the lowest DC power settings. Thank you for inspiring the confidence to do this. kzfaq.info/get/bejne/aLCjlqyKs5bOYX0.html

@BuntersYard 3 жыл бұрын

Well done. These are fairly easy locos to work on and understand. Glad you have had a good result

@raymondleggs5508 2 жыл бұрын

needs traction bands or bullfrog snot on the wheels

@BuntersYard 2 жыл бұрын

Yes. Snot is the solution

@antoinebesnehard 3 жыл бұрын

Thanks for the video. I got one of these too, in blue BR livery, and was planning to fit it with a decoder. My suggestion to handle the wheelslipping: make the thing a lot heavier. I'll try it on mine and let you know how I solved the problem. Or maybe you already found a solution? And by the way, thanks also for the other vidéo, I really enjoyed the eBay rescue series !

@BuntersYard 3 жыл бұрын

Thank you. Let me know how the extra weight goes. I’m going to try Bullfrog Snot which it a paint on traction tyre sort of thing. I’ve seen it used a few times. I’ll post a video when I’ve tried it.

@antoinebesnehard 3 жыл бұрын

@@BuntersYard I've seen this in a video by Charlie from Chadwick kzfaq.info/get/bejne/bKqTfMJ1vrunYIk.html. I think I'll try extra weight first. Will certainly keep you updated.

@antoinebesnehard 3 жыл бұрын

@@BuntersYard Hi there. I just took a look at my own Class06. I see there is a lot of free (lost) space in front of the motor, as well as above the motor in the elevated part (fuel tank?). I shall also consider putting some weight on the floor of the cabin, which is invisible anyway. I'll have to wait to start working, no decoders left but I'm about to order new ones. Best regards.

@andrewbergman9315 4 күн бұрын

I also have one of these in BR blue to convert though I want to see if I can fit a sound decoder and a small speaker in it.