Fitting Springs, Shackles and the Rear Axle to my Land Rover Series 2 Restoration
Рет қаралды 9,450
Күн бұрын
@thomaska8621 2 ай бұрын
Hallo George. Sehr ausführliche tolle Videos. Ich kann viel lernen. Habe einen Land Rover Serie 2a von Baujahr 1964 hier in Thailand. Viele Grüße
@mbrown6930 2 жыл бұрын
Great video, thank you.
@bambusizdrowie3979 Жыл бұрын
Nice job !
@ThePyklet 3 жыл бұрын
Machine vice... Fingers are important. (Top safety tip there!)
@HalfJobGeorge 3 жыл бұрын
Yea I actually have 2! Maybe I should try using them more often haha
@TheFatgingercat Жыл бұрын
How do you know that the spring was the wrong way around?
@HalfJobGeorge Жыл бұрын
It has an offset at one end and it wouldn’t have lined up
@jjf6893 3 жыл бұрын
Great vid mate. 👍 Have you got a Facebook page?
@HalfJobGeorge 3 жыл бұрын
Yes its facebook.com/half.job.george Thanks for the comment 😊
@Rosiesgrandad 3 жыл бұрын
Pretty sure the shackle bolts don’t have washers as standard. Edited to add, confirmed by checking the parts book, no washers at either end of the shackle bolt.
@HalfJobGeorge 3 жыл бұрын
Oh right, thank you, puts my mind at ease! It just feels wrong 😂
@HeinerStorchennest1 Жыл бұрын
Is the thread drill bit drawn down by the thread itself or do you push a little bit.
@HalfJobGeorge Жыл бұрын
Apply a little pressure to start it off and then just the weight of your hand to balance the spring in the pillar drill
@mikeharrison5087 2 жыл бұрын
Good information and videos as always on the channel! Would you rate britpart gearbox bearings? I'm building my box up and some bearings aren't easy to get in japanese makes
@HalfJobGeorge 2 жыл бұрын
I try to avoid all Britpart things but I don’t have any experience on gearbox bearings unfortunately. How did you get on?
Half Job George
Рет қаралды 1,3 М.
Half Job George
Рет қаралды 9 М.
Half Job George
Рет қаралды 6 М.
Restoration Skills
Рет қаралды 12 М.
だぶるあっぷ
Рет қаралды 13 МЛН