Fixed a 10 year old front loading washing machine F06 error code by adjusting the motor drive belt and fastening a loose connector with a 2" clamp (photo below). It may be able to fix any other brand or model.
Пікірлер: 11
@Jorgem10102 жыл бұрын
Shaft or bearing are to blame. It’s not belt issue or pulley issue.
@fredrossi203611 ай бұрын
In the end Jorgem1010 was right because the belt adjustment that I did was temporary (like 9 months) and then the shaft wearing caused more and more of an imbalance. It is possible to replace the shaft and bearing but it is a lot of work and in my case, I replaced the whole unit. The only reason I am not deleting this video is that it shows many parts that could cause an error and may hopefully help someone to diagnose. Jabbablink2 are you sure that your noise comes from inside the motor? This motor is built tight so that you cannot even open it to change the coils. Maybe lubricating the pulley bearing that is nearby the motor or maybe replacing the belt? I don’t know but you could open it up and listen closely to see where the noise comes from.
@girohead2 ай бұрын
I appreciated this overview with other possible causes. Many searches have seemed to stop at simple solutions like clogged filter.
@Jabbablink211 ай бұрын
hi Fred. I have the same machine, I don't have this error code but the machine seems to be getting louder during the spin cycle. Before I go digging into it, do you know if the motor needs oil? The electric one on my table saw does. Just curious if you knew. Thanks.
@fredrossi20365 ай бұрын
I do not think so. Are sure the noise is from the motor?
@agerot Жыл бұрын
Лучше поменять ремень. В России он стоит в пределах 20-30$. Срок службы ремня обычно в пределах 10 лет.
@fredrossi20363 жыл бұрын
Clamp photo. Disclaimer, use at your own risk: cyberagra.com/images/clamp.jpg