Thank you so so much! Not sure why I didn't find this video the last few times I looked for a way to fix the loose slider on my bolo bracelet. This has been a life saver! Thanks!
@belengarcia86063 жыл бұрын
Could u do another video on the knot part I couldn’t see
@christina2405414 ай бұрын
Thank you so much! You're a genius!! Lol I was looking on Amazon at little silicone O rings as a solution lol
@belengarcia86063 жыл бұрын
I have this same exact problem right now but I can’t see where your putting the needles , in which hole
@NH-re7ym Жыл бұрын
The part that is important to see is so blurry that it does help at all.
@feliciau33683 жыл бұрын
Thank you SO MUCH!
@LiLiJughead Жыл бұрын
This is a good idea. I'm going to try it.
@shikhashah93882 жыл бұрын
It is very blur .please make and upload another video
@tinachristoxo3 жыл бұрын
I have the same problem - but the two strings of my bracelet go through the same rubber hole. So I can't do the same process as you because your heart has two holes... Any advice?
@janaziluk16553 жыл бұрын
I don't have any solution to that. 🤔
@jojomang30162 жыл бұрын
Maybe you could just go behind and between the chains?
@JesslynHendrix2 жыл бұрын
I'm going to try this on my bracelet. Mine has a single hole, but the rubber piece has two sides. I am hoping that in our situation, we can use less thread but with a smaller needle.
@christina2405414 ай бұрын
Mine is one hole also, I'm just gonna wrap it around the ball and not care if I can see it as long as it's tighter. But I'm gonna try what the above user suggested first in trying to wrap it around the chains.
@christina2405414 ай бұрын
I've added a little silicone ring under the ball of a couple of my bracelets that became loose. I just push it up behind the ball and it stays.
@yrduasomar2 жыл бұрын
How do I fix the end? The ball at the end of one of the chains came off :(
@abbiegump6012 жыл бұрын
That’s what happened to mine. I’ve been trying to find a solution for so long 😭😭
@christina2405414 ай бұрын
Can a tiny hook go through the end of the chain?? If so you can out on a tiny hook (ring) and then on that you can put any charm you want. But if it's one if those that's not a chain with links then I'm afraid your only solution is tge jeweler or learning how to solder yourself. Good luck ❤️