Fix V8 Mercruiser Stalling & Big Flat Spot Easy

Рет қаралды 82,002

3 жыл бұрын

This should be the same fix for any boat with a dirty carburettor V8, V6, 4cyl different but same.
Bayliner 5.0L V8 Capri has a huge flat spot and stalling when taking off, this fixed the problem and runs great again. Happy Boating!

Пікірлер: 38

@bubuzgt 2 жыл бұрын

You just saved me over $4,000. Thats the estimate I received from the boat mechanic. My boat is now running better than ever. Thank you

@fixitdan5248 2 жыл бұрын

Good work mate for having a go at it yourself, helping each other out with a bit on knowledge is what it’s all about.

@keepitreal5148 2 жыл бұрын

Thanks man!!! I will try cleaning out my carburetor

@JohnTaylor-zq7go 2 жыл бұрын

excellent job there....well done

@dianavassallo6852 Жыл бұрын

THANKS GREAT VIDEO

@higginsoutdoors1224 2 жыл бұрын

You need to take a look at your cutoff switch, when going from neutral into gear it stalls the motor to make the shift easy, when its not tuned it will ground out your ignition and cause the engine to die when shifting.

@fixitdan5248 2 жыл бұрын

Thanks I’ll take a look at that next time it has problems.

@ParsonsDesigns Жыл бұрын

Awesome!!!

@isaiagutierrez1795 11 ай бұрын

This is the same thing going on with my boat

@TammyKennedyBlake-fc3iq 7 ай бұрын

99 Dodge pickup what color are the fuel pump

@mchaves7663 2 жыл бұрын

When you push the throttle, does it feel stiff? mine is stiff, I was wondering if that's normal. thanks for the video, very interesting.

@fixitdan5248 2 жыл бұрын

It was a bit stiff, I lubricated all moving parts & tried getting some spray up the cables. That improved it enough to live with, you can also disconnect the cables & make sure everything in the motor moves freely- then you’ll know what part it causing the problem. Hope that helps

@yonivr9704 Ай бұрын

What kind of spray did u pit in the cables? (Break cleaner? Silcone spray?)

@heavydssutton9083 3 жыл бұрын

Where did he get the first part from , doesn’t look familiar on my 350 5.7 ??

@fixitdan5248 3 жыл бұрын

Hi, it’s a 1999 5.0L Mercruiser, the 350 might have a different manifold carb setup. My other 350 is fuel injected which then the stalling is probably shift cable adjustment like the last comment suggested. Hope that helps..

@j_rainsgoat3929 2 жыл бұрын

my boat bogged out on me this weekend would idle and run great then got to a sand bar hung out for a while when shifting into gear and giving it throttle it would bog out. took gas cap off and it took off like a scalded dog

@fixitdan5248 2 жыл бұрын

Interesting, must have a blocked breather. Where I live the wasps in summer will make mud nests in any little hole they can find, my chainsaw wouldn’t start & sure enough the exhaust was blocked with wasp nests.

@bxbmbr766 2 ай бұрын

Same thing happened to me but in the water

@aydengaming3883 3 жыл бұрын

Just bought a boat it runs fine at idle put it in gear and give it lil or to much throttle and it, I had my uncle looking in the carb when I start it he said the jets was not spraying he tap it with a screwdriver and the jet start spraying but it still wasn’t enough to keep the engine on

@fixitdan5248 3 жыл бұрын

Hi, sounds like a similar problem, best to pull carb apart, clean & even put a new gasket kit through it if you don’t know the service history. Also check clean or replace fuel filter & water trap if it has one..

@pcough100 Жыл бұрын

I've got a problem where if I pump the throttle all the way forward, a small amount of fuel will squirt into the intake, enough to start the engine, but then it only runs for a few seconds. Fuel pump?

@fixitdan5248 Жыл бұрын

Could be fuel pump mate, be a matter of elimination. I’d start by disconnecting the line & put it into a bottle and see if it pumps fuel with nice flow, if that’s all working then time to pull the carburetor apart, might just be a stuck needle & seat.. let me know how you go.

@pcough100 Жыл бұрын

@@fixitdan5248 actually it ended up being the exact problem you dealt with in your video, you saved me big time thanks a million!

@fixitdan5248 Жыл бұрын

@@pcough100 Awesome, glad it worked out. Don’t forget to subscribe 👍

@pcough100 Жыл бұрын

Just did!

@grommdk 2 жыл бұрын

your belt seams abit lose? :)

@fixitdan5248 2 жыл бұрын

Yes, all tight now thanks👍

@sharonbraselton3135 Жыл бұрын

Boat like this ektricik Bayliner 32ckw. 30 Mike rabfe telsa cl 34.8 mole apps vater 38 kw 36 me BMW pater 41ckw 39 mile range

@cainbird8774 3 жыл бұрын

It’s your shift cables I just had my boat fixed same set up 1998 crownline

@fixitdan5248 3 жыл бұрын

Shift cables are good, was just carburetor, runs perfectly now

@aydengaming3883 3 жыл бұрын

Yo I have this same problem

@cainbird8774 3 жыл бұрын

It’s your shift cables most likely just had some problem

@oddlyrightoddlyright2475 Жыл бұрын

I have a 23ft 225 sundowner with a Omc 5.8 it runs perfect but won’t go past 3,000rpm spec is 4600,4800 full throttle anyone have any ideas?

@fixitdan5248 Жыл бұрын

Hi, haven’t worked on that engine but if it’s old school & not fuel injection, I’d start with the fuel system, check fuel filter, fuel quality, pull carburetor and clean all jets. Then electrics , spark plugs, coil, distributor leads etc. Depending on carby , the secondaries maybe blocked only giving half throttle, if it’s electric injection could be some limp mode etc

@oddlyrightoddlyright2475 Жыл бұрын

@@fixitdan5248 thanks man I’ll definitely start with fuel

@georgeforall Жыл бұрын

@@oddlyrightoddlyright2475hey! Did you find the problem? Mines doing the same thing .please let me know.

@oddlyrightoddlyright2475 Жыл бұрын

@@georgeforall my tach is off top speed is 40-45mph for my boat and it’s hitting the mark

@georgeforall Жыл бұрын

@@oddlyrightoddlyright2475 ok . Thanks!