After having issues with this and having been told to replace this and that, i tried this video and it worked perfect. Car runs like new. Thank you so very very much. Im one happy camper cause i love my car.

Thank you very much for this sir. I appreciate it! Very helpful

To anybody who’s wondering if this works, yes. It works a 100%. This might be a typical problem for this type of car.

Great video i have a 2008 mazda 3 mind now randomly stalls out and dies when i turn it seems to happen the sharper the turn but it does it both ways..its random as hell though. Car sounds pretty good.

Great video

How about in my cars case i would have the put the relay in just to get a/c or heat? It only goes at full blast.

Did this repair last? What about problems with spark plugs and ignition coils with these

I can confirm this fixed the problem. Same situation, changed the battery and the car was idling very rought.

So my rpm’s just around but I’ve done this procedure multiple times other then I’ve replaced the battery I havnt done that in 1-2 years but my idle does surge roughly any more tips since this video?

Throttle body forced limit, speed sensor for abs will do it to.

YO so,my 07 2.3L mazda 3 doin this started like within 24 hours after an oil change, I think there was a little extra oil put in too. But the battery was never replaced and it usually starts ok but it still will crank and crank so ill stop put it in neutral an pump the gas. But then it'll sometimes make a grinding noise when it starts up. Also ive noticed I think it happens when downshifting quickly but the oil pressure light flashes and it'll make the same kind of grinding noise. Check engine light on for o2 sensor 1 bank 1. All kinda spring up on me real fast

What if the Mazda stalls when you leave it running? Restart it and keep the timer going or restart the timer itself with the car?

I recently changed both cv halfshafts and my car suddently started stalling, it stalls when in drive and press accelerator also it dies out when driving then shut off for a.minute and then works again bit keeps stalling.

can you do something on a o2 sensor for this same car ?? i was getting a p0134 code came to conclusion needed to replace o2 so now I have a new o2 but a different code came up P2195. looked this up and I cant figure out how to fix it ant ideas ??

May mzda 3 1.6 model rpm is the same with the ac on aroung 1000k rpm is it normal?

that metal on metal sound at the moment of ignition @2:10 is nasty. my friends mazda does it too. I"m sure is no good. my mazda 5 does not do it.

I haven't changed the battery but sometimes the rpm fails whenever the car stops(Brake) or goes slow the rpm would sometimes go off when I do these things in the car in order to let it go again, i need to chage the gear from Driving to Nitro or Parking and restart the car. over all, the car treats me good it runs great I just want to know what's going on with all the stalling that's been happening often the vehicle was bought used and it's my first car so I don't know much about the problems It could have or if their servere problems. The AC doesn't work by the way.

Do you need to remove the battery and wait a little bit before doing this?

Same here the rpm is up and down if i turn on the a/c, but when i turn off the a/c the rpm is stable

I changed by battery and the idol is weird now and my car will act like it's peering off and the screen will say goodbye and the dials will go side to side ...but the car is still running??? I don't know anything about cars but I assume maybe it's not the right size battery for my Mazda 3

My 2015 Mazda 2 has a rough idle, but I did not replace the original battery yet. Do you know what I can do to resolve this issue? Should I disconnect the battery and reconnect it? What is the process? Thank you!

I got a new battery 3 months ago and the rpm been going up and down ever since .. will it still work if I retake the battery out and let it run like the video ???

Try food mode fr Ford (,manufacturer) basically Mazda . They came out n said to stop the rattling on some of the cars and also to prime oil filters with the cars system. Don't do it by hand. . When u turn on car keep gas pedal mashed in to the floor to oil and prime the oi syste.. giving more lubrication and reducing wear n tear wear it matters most . at start up . Once u release the pedalthe car will turn on allowing for a better start up.quiter safer etc...again from the manufacturer not some bs I made up

I have a rough idle and code p0507 without changing the battery, and suggestions?

I actually did this to my 2010 Mazda 3, except for letting it idle for 15 minutes with AC on. I just let it idle for 20 min with no AC and then drove off. The thing is that now my idle is good with or without AC, but when driving with AC on in lower gears (especially 1st gear), my rpm will drop heavily and car will slow down as soon as i hear the AC compressor kicking in (I know cars, especially gasoline cars, lose lots of power when compressor starts, but this is too much). Do you think redoing the procedure and let it idle with AC on would help with my rpm drops while driving, or that is just for bad idling?

My car doesnt pick up speed it goes slow and even slower after jumping a hump

if its nessasary happend after reset the battery? or only replace

Will it work on a 07 speed3??

mazda gang

This is a same problem I have but I was at one garage but their telling me that my car has a problem with valve, can you help me out to know whats the problem because I really don't believe these guys. Because I only changed the head gasket after all it start doing that..

So, I’ll start from beginning to end if anyone can please help me out… Belt snapped on mazda3 2.0 2009, I replaced both belts. Noticed the overflow tank had a small crack in it, cause it did get hot when the belt broke. Anyways, replaced the overflow.. then, noticed it was leaking from the coolant water outlet. Never heard of that thing until now. So, replaced the water outlet, put everything exactly back together how it was, yes it did include taking battery and the battery box out. But now, it keeps dying on its own. Now I’ve noticed when I turn the wheel all the way in either left or right direction, it dies. Steering wheel and “!” Light comes on for a second. The “abs” light comes on for a second too. I don’t understand? Is this just the case of…”fix one thing, another thing happens right after”? Cause bro I’m so pissed. Gonna look at it more tomorrow.

My rpms are stuck at 2 and my car stalls and shuts the radio off and turns itself back on

My 2005 Mazda 3 speed meter not working. How do I fix it please?

2005 Mazda 6 runs when cold and once it’s at temp and it idle it stalls

I added an amplifier and started to have high rpm. Disconnected the amp (thought it was the amp) and didnt change back to normal.

What if I can’t get my car to stay idling?

What should we do? When the rpm moving up and down...i have mazda 3 model 2005

Hi , i have a 2006 mazda 3 hatchback automatic , 2.0L , i got problem with my transmission when i put the gear in R - its make a hard noise from the transmission.. do you know this problem? Ty..

I tried this and it ran fine but the next day it was stalling again.

After you do that you'll run out of gas before driving it around

Why would or does this work? It seems like that wouldn't fix anything. What is this even doing I dont understand how doing nothing fixed your car.

SO

Mazda sucks