Flipdots!

Рет қаралды 42,675

Tyler Bowers

Жыл бұрын

Пікірлер: 25

@omeiga 9 ай бұрын

now play bad apple on them

@GummySharp 10 ай бұрын

I've tried looking at purchasing a small display for hobby purposes, however the only options I've found online are in the range of $90-$150 for a section, smaller than the palm of my hand. How much did you pay for your setup, with its size?

@tylerebowers 10 ай бұрын

I paid $800 for a 16x112 Luminator setup.

@polygonthree 8 ай бұрын

I got four from an old tram. I should probably make a controller for them sometime

@____________________________v. 10 ай бұрын

I’m pretty sure that these will or has been used for bad apple.

@tylerebowers 10 ай бұрын

Might code bad apple for it when I finish

@flipwonderland4181 9 ай бұрын

kzfaq.info/get/bejne/bJmdkt2oxseyh3U.html

@trentHV 10 ай бұрын

Nice

@VolumetricTerrain-hz7ci 8 ай бұрын

Can you make a continuous flipdot display, with rotating cylinders or balls, with the one side black and one yellow? Have been an awesome analog display! Cool video by the way!

@tylerebowers 8 ай бұрын

You could but this method using electromagnets works the best out of other methods I think.

@TyFuhrman1 3 ай бұрын

I think I have this exact display, but I have no idea how to connect to it to control it :(

@tylerebowers 3 ай бұрын

tylerebowers.com/posts/luminator/

@byronthevideomaker 10 ай бұрын

Isnt this what they used back in the old verisons of family feud

@tylerebowers 10 ай бұрын

It seems so, according to wikimedia commons: “Richard Dawson and Ray Combs versions of Family Feud”

@byronthevideomaker 10 ай бұрын

Yeah never really liked how they covered the flip dot board with CGI when dawson returned in 1994

@MikeHarris1984 Ай бұрын

But can it play Crysis?

@Hotfuzz25 5 ай бұрын

Could you 3D print these instead of purchasing them?

@tylerebowers 5 ай бұрын

They are difficult to make, the dots have embedded magnets and there are also wire wound electromagnets for each corner. It’s possible but it’s a lot of work.

@volganin2716 9 ай бұрын

Where did u buy this display?

@tylerebowers 9 ай бұрын

Junkyard bus

@volganin2716 8 ай бұрын

@@tylerebowers Lucky u

@lochlanroche8528 9 ай бұрын

Hi, I have a flip dot board made by Hanover and need a bit of help, Mine worked fine for a while, but i cleaned the dots as they were dusty after years of being on a bus, and now alot of the dots stick on one side. I have removed them and cleaned them with isopropyl alcohol but alot of them still seem to stick on one side making the board pretty useless. Would you have any idea as to why the flip dots stick?

@tylerebowers 9 ай бұрын

Voltage too low, sticky surface, high turning resistance, controller too fast, weak disk magnets. These are some of my guesses.