Installation process for one of our Flowmaster Exhaust systems for the ever popular C10.
Пікірлер: 13
@hdrolling2 жыл бұрын
I was hoping this was going to be a bolt on for a 72 with SBC 350 and long tuber headers, it wasn't completely. The sections provided that go from the manifold connector to the exhaust system were not flared to slide over the 2 1/2 connecter. So the most important part that connects the long tubes to the exhaust system still needed to be taken to a shop and expended and welded. Nothing like running open headers to an exhaust shop 30 minutes away through town. If I would have know this I would have just drove to the exhaust shop with open headers and had them build me a complete custom exhaust to start!
@hackertheslacker7 ай бұрын
That's a sweet sound
@KnuckleHeadGarage274 жыл бұрын
I love flowmaster that's all i ever use . I have 40 series 3inch single in single out on my 85 s10 2.8 and man sounds like a v8 going down the road and at idle is the best . Have a video on my channel. I'm about to buy another same type muffler for my other vehicle
@civitec3 жыл бұрын
Wooooow beautiful sound and beautiful truck. 😍😍
@IgnisMan4 жыл бұрын
Cool Sound 👌😎
@northonlopes46804 жыл бұрын
Nothing beats Flowmaster
@jeffharris854815 күн бұрын
how did you get stock exhaust manifold pipes past the big tranny support. There doesn't seem to be enough room to go under them>
@brunoclark84722 жыл бұрын
what suspension set up is on that truck and tires size please
@johnperales54313 жыл бұрын
you need to make this kit for a 4x4
@colbygentry92103 жыл бұрын
Exhaust systems don’t change depending on whether or not your truck is 4wd. You could use the same kit on a k series truck :)