Thanks for making this video! Made my life way easier.

You just saved me a ton of time. I appreciate you

Thank you thank you.. you saved me a ton of time.... I just used a small Alan wrench. 2007 expedition here.

Just did my 2014 Navigator, discovered complete removal unnecessary (accidentally). Access the tabs behind glasses holder using plastic blade that came with bulbs kit just remove the light cover by releasing the tabs and the moon roof switch cover by its tabs. Using needle nose pliers grab the bulb gently and wiggle it while pulling on them and they will easily pop out. Use pliers to install led bulbs with correct polarity. Caution: old bulbs will be HOT so have a safe place to put them where they will not melt or burn anything. Fortunately I had the AC on so I held them in front of the vent for a few seconds and they cooled quickly. The middle map lights have the tab you mentioned but it is offset from the center one. Using a special tool (butter knife) it popped out easily and again removed bulbs with pliers. The rear one at the lift gate is a different animal, nothing easy about it so, good luck on that one. Hope this helps. Blessings! 😉

Thank you! Merry Christmas!

Thank you!!!!

Thank you 🙏🏼!!!!!!!

Thank you sir, appreciate it.

Easy peasy, just did it. Thank you for your guided assistance. Now if only I could figure out my vanity bulbs!?!? 😊

Great video, can you please share the link to the lights? cant seem to find them.

Excelente 👌

OR .... OR .... one can remove the entire light/glasses case assembly, which is only held in by tension clips and pulls right out without the risk of breaking tabs.

What about wrapping duct tape on the bulbs and pulling them out instead of removing the whole housing?

Are the led bulbs you installed dimmable?

What bulbs did you get, like code wise?

I 👀 you!!