Great commentary and camera work. Interesting look into the ford ranger 3.2. Don’t forget as per ford bulletin for ford ranger 3.2 diesel as well as Mazda BT 50, that oil change must be performed in ten minutes when doing regular oil change. In this case after rebuild or exceeding the ten minute time for regular oil change, they say to fill 15 litres and allow engine to stand for a full day 24 hours. Then use 6 bar compressed air pressure through a breather hose to put pressure into system when you see oil come through open oil filter housing. Watch the oil filter housing for any oil pushing through, this is an indicator that the oil pump is full and primed. Refit oil filter. Reconnect the battery Crank the engine in ten sec intervals Leave the oil cap off and observe the oil pushing up over the hydraulic lifters Secure oil filter and cap DO NOT REV THE ENGINE! DO NOT DRIVE THE VEHICLE! Drain the engine of excess oil. Ensure you do not exceed 10 minutes Close the sump screw with a new sump washer Check that the oil pressure light is off( allow 5 seconds) Remove the oil cap to ensure oil is flowing over the hydraulic lifters.

Ranger Danger!!

Another great video.

some horrible peny pinching designs, beautiful bearings though, these videos are fun and informative.

Says part 2..... but is part 1 🤷‍♂️

They good engines ?

So what causes piston to burn up on these 5 cyl Ranger motors people forget these are no more real deal FORD then flying to the moon trucks are made in Thialand