You done great... alot pressure camera, a class, or a group of people, plus explaining while assembly... a great job.
@zeekdornier2946 Жыл бұрын
Missing the throw out bearing I think it’s called. Between 3rd and 4th gear. It fits over that special D shaped washer with the snap ring. Also missing the oil slinger plastic piece on the front side of 4th gear that actually lubricates that bearing and the needle bearing between 3rd and 4th gear. Just a heads up for anyone else who’s rebuilding their m5od. I only know this because I followed these videos to rebuild mine and took special care to pay attention to detail when taking my trans apart. All in all pretty solid video and saved me money and time. Thanks
@xxv853910 ай бұрын
This guy teaches and films like a child
@zeekdornier294610 ай бұрын
@@xxv8539 yes, but the info I needed was pretty much there… I would’ve done the video much differently
@polymetric26144 ай бұрын
All the docs I see just call it the the main shaft thrust bearing. The throwout bearing is also a thrust-type bearing but it's in the bell housing between the clutch fork/slave cylinder and the pressure plate.
@zeekdornier29464 ай бұрын
@@polymetric2614 I’m not exactly sure of each name, I just know what the bearings were called when I had to order them online. Different places called them different names. Either way, there are lots of bearings to pay attention to
@mikenundahl-oc9vr Жыл бұрын
Your a credit to our community and this is excellent instructional video and it has spared me a serious headache. I really appreciate what you did hear so thank you very much!
@schneider14924 ай бұрын
Instead of the brass punch we usually use the handle of the hammer. Also if you taking put a punch or center punch into the center of the counter shaft you can lift it up with one hand while you put the bearing in with the other on the front side...
@mikenundahl-oc9vr Жыл бұрын
Thanks again, very helpful and useful!
@schneider14924 ай бұрын
Also if you use a little assembly lube your needle bearings will stay in place better
@dhangejr5 ай бұрын
hey, on that front retainer, There is 2 seals but do you use any RTV to seal it or a gasket? THANKS
@RonComstock10 ай бұрын
where is the thrust bearing that goes between 4th snycro and input shaft that fits around the washer with flats under snap ring?
@seanthompson39945 ай бұрын
Not in the transmission rebuild kit I guess
@johnwurst12692 ай бұрын
Took long enough.
@xxv853910 ай бұрын
9:40 Amateur hour. Doesn't know what a deadblow is