Hey, I used your video to help me change mine all was fine, finished and now have the worst vibration coming through the van any ideas? Cheers
@diykhan25 күн бұрын
Hi. Yes thats the other side of drive shaft not fully into the slot
@diykhan25 күн бұрын
U need to line up the grooves n then tap it into the slot opposite side to the hub.
@diykhan25 күн бұрын
Thats very common when u change the cv joints or cv boots. The opposite side knuckle comes out which need lining up into grooves n then needs pushing in.
@mhfencinglandscaping31025 күн бұрын
The opposite side?
@mhfencinglandscaping31019 күн бұрын
Thanks @diykhan it was the bearings on the outside of the driveshaft. TBH anyone looking to do this just replace the whole driveshaft, much easier than seperating the cv joint. It was out and back together within 45 mins! Thanks for the video 👍🏼
@johnp66364 ай бұрын
Pain in the ass them transit mk7 and mk8 cv joints never been able to get them off
@TheUltimate657 ай бұрын
Some cv jont have a clipring of nock of only, some cv jonit have a clip ring you must open up before yoy can nock off