This video shows the Land Rover Freelander 1 TD4 intake and vacuum system flow and what each part is.
Пікірлер: 19
@normanbalkanbiznet6314Ай бұрын
excellent description. superb
@freetimeonlineАй бұрын
thanks.
@user-rg6jf5pw2q8 ай бұрын
Thanks mate, new to the freelander 1 td4 facelift. Your vid gave me loads of info. Spot on. 👍
@freetimeonlineАй бұрын
glad it helped.
@PIRRU4446 ай бұрын
Hi I have a 1 trying to pull an rzr polaris on a trailer in hills finding it really hard some times dosend drive turn off in hill ??
@eddieMurphy1111110 ай бұрын
the tube of the vacuum rail onto the front of the vacuum it should go on the back and the front vacuum pipe going of the front onto the turbo actuator or you will have problems especially if it is a auto
@freetimeonline10 ай бұрын
I assume you’re referring to the vacuum chamber. Someone else mentioned this a while ago so I checked and the way I have them fitted is correct. When I fitted the new pipes I made a note of where the original pipes were and fitted the new exactly the same.
@freetimeonline10 ай бұрын
See here that shows the vacuum pipe routing and it's the same as mine. www.landyzone.co.uk/land-rover/td4-vaccuum-pipe-diagram-request-again-solved.287163/
@eddieMurphy1111110 ай бұрын
believe me please especially if you have a auto box what you have is wrong asi said the rail vacuum pipe goes onto the back of the chamber and the one on the front of the chamber goes over the engine and down to the turbo actuator we have had freelanders for nearly 24 years and the vacuum chamber should have valves in it @@freetimeonline
@cliffperry84708 ай бұрын
I’ve got a Td4 2004 auto and what Ive done taken the egr off for a blanking plate but it don’t have a vacuum pipe on it so what do I connect the pipe off the original egr too .
@freetimeonline8 ай бұрын
@@cliffperry8470just put a blanking plug in the end of the pipe, use a tight fitting bolt or similar.
@chrishosking279 ай бұрын
We're did you get the red pipe from? I carnt find anything but standerd?! Thanks
Hi.. my freelander has no power at all but its not smoking. Could it be these small pipes as well?
@freetimeonline10 ай бұрын
It could be, very easy to check these pipes for holes/splits or soft spots that will cause the pipe to collapse.
@sicelogeorgeson721210 ай бұрын
@@freetimeonline thank you for the prompt response.. ill thoroughly go through them and will let you know what i find
@robber930510 ай бұрын
Really useful vid thanks ! Subscribed. My td4 is getting smokey on acceleration and intermittently has flat spots on acceleration coupled with big clouds of smoke as it hits the flat spot. I disconnected the maf......no change in symptoms.......any ideas ? Thanks 😊
@freetimeonline10 ай бұрын
@@robber9305 these symptoms can be caused by a blocked engine breather, there is a upgraded part available on eBay made by BMW which is a simple replacement for the old foam filter, it’s a fairly easy job to change it. Search eBay for ‘freelander 1 td4 engine breather’ and they should come top of the results. Worse case scenario is your turbo oil seals have badly failed and it’s about to pack up but this is rare.