I was stuck in the middle of the freeway and this helped me start up my truck. thanks man you saved me

Thanks for posting this. I'm at arest area in Nebraska and mine done this. Cut the power and waited 5 min. Good to go now

9-20-23 & this video just got me moving thanks alot 😁🏆

bro you saved my life i was at a port and my truck would not start lol actual life saver

This video just saved my life!!! It’s 6-11-23 and this video helped me a lot. THANK YOU!

I followed your steps and it worked for me, thanks for doing a good job 👍

You saved my ass this morning. Thank you sir !

You Saved $$$$$$ and downtime. May God Bless you. May be while sleeping my hand touched the button and it was ON so turned off and disconnected and it fixed the big issue.

This worked on a 2016 Freightliner as well, this is wild that this is part of the wiring scheme to block the starter, is switches in the sleeper ...

Had this happen in a dock in Columbus, turned off power for 5 minutes and it started up. Got back to yard and company replaced the whole stalk and it happened again. Did the truck you showed and turned off main power for five minutes. Got it to start.

Thanks a lot for the info bro I can continue rolling now thanks to you

You are a life saver bro.

Also same warnings came out on my Cascadia while batteries haven’t hold the charge as they should so after few attempts to start the truck with jumpstart it kick out same sign. Been towed to dealer and while waiting in line decided to install new batteries and there’s a miracle - truck started with first attempt.

7/24 Hey, just used this video yesterday. Pulling those wires worked on clearing the code but it still wouldn't start and the code came back shortly after in my case. I ended up disconnecting/connecting the ground on batteries for a quicker power cycle and that did the trick. The starter activated but it needed a jump at that point which I had with me

Thanks man! Saved me some frustration

Thank you! It works perfectly!!

Thanks for the help

2024 Freightliner don't have that kill switch. Just tried helping a guy, 24000 miles on truck same issue. It eventually resolved itself after he was stuck in door 30 minutes

Thank dear! It worked perfectly for me. Thank you for saving my day

Wow thanks for the help I got it working.

You saved my life.. i was at where no road service thanks it works

Why does this happen?

Went to turn my truck on today to get going, this code came up I turn the kill switch off for 10-15 mins and it started after that. it did took me Liki 3 times for it to actually Start

I got the same problem, New freightliner I buy😀👏

yep this was helpful for me

Thanks, very helpful

Just saved my life

Don’t know if this might help but I do not have a Killswitch on my 22 what I did do was put the key on the start position for five minutes turned it to the off position and started back up and it took away the stalk switch right errors

Thanks

Have fld120 1991. And I’m happy no def no electronic on board no headache 😂

Absolute life saver!!

Worked!!

I have same problem my friend it's the starter you have to hit it with hummer it's on the top of the transmission

Just reset you main power. Reset for 5 to 10 mins. Cycle the key 3 time the fourth start .

Same trick work for me. Did this code comeback for you after starting it like this?

You think the hard reset of battery (unconnect cables for 20 min will not remove the message?🙏

Will ot stop your accelerator from working ?

I tried this too when this happened and it didn’t work. What I did I have 2 keys the one in ignition was key copied. I took it out of the ignition and put the original key in and it started right up

lol thanks man 😅

My Freight liner Cascade 19 ‘battery died after jumping attempt the same error message popped up “starter blocked”any solution for this model?🙏

@ddtruckdriver My 2019 Freightliner Cascadia truck turns on perfectly fine and drives . The message pops up and off while driving especially when I hit some bumps in the road/ or even when driving it shows up and then after 2 seconds it goes away the error message. Should I be concerned? Any suggestions, greatly appreciate your responses!

My truck is brand spanking new and keeps switching into neutral while im driving, mostly around gear 5. It will flash the gears at me and will not go into gear until i stop and switch from drive to neutral and back to drive.

👍

I'm going through this right now , nothing here is helpful, I believe that I forgot to take it out of nutreal and all the Air leaking out of my system has caused my problems. I left the truck in drive and it leaked all my air out so I can't put it back into netural so now because the truck is leaked almost the air it's not letting me start the truck.

Worked like a charm, thank you sir.🫡

It was a big help, thanks!!