Fridge Freezer Evaporator Fan Replacement (Multimeter Test Guide)

No video

Fridge Freezer Evaporator Fan Replacement (Multimeter Test Guide)

Рет қаралды 108,041

eSpares

Күн бұрын

Пікірлер: 12

@walter9724 10 ай бұрын

I had an EF code on my hisense fridge and it came up as an evaporator fan motor fault. I removes said fan motor and disassembled it and cleaned the brass bushing and added some new grease to them. Both before and after cleaning the ohm's were 4.56. And after re assembling it the fan started and the code has gone. It is still running quietly

@lyianx 8 ай бұрын

Mine had black red and green wires. The green was ground so it didnt do anything. But when tested, it did test at 9, but the fan is bad despite the reading (its stiff to turn and the fridge doesnt turn it at all) So guess it depends on the fridges motor?

@pierregeoffray5961 6 ай бұрын

The fan on my fridge works all the time. Is it the fan the problem or something else? Any help welcome. Thanks

@captainawesome8632 9 ай бұрын

I have a samsung rsh1dtmh. I had the grinding noise but thought it was ice buildup. I replaced seals but now I’m not sure the fan works. The temp is cold at bottom and warm at top The resistance is 19.3 across black/white. The fan makes no noise; I would have thought I could hear it spinning if working?? What else could it be?

@marcomendonca7543 5 ай бұрын

Hi there. On my fridge the same is happening. But on this case I don't hear any grinding noise. Only the bottom cold and the top warm. My resistance reading is at 19.4 across black/white. Can you please let me know if you fixed your problem and what you did to solve it. Thanks

@funkycowboy 10 ай бұрын

My wires are white, red, blue, and yellow. Which ones do I check?

@4TT4CK 9 ай бұрын

you figure it out yet?

@funkycowboy 9 ай бұрын

@@4TT4CK yes. I had to use reader glasses, because some wires had a stripe down the middle. It looked Blue solid, but it was blue with a white stripe. I connected it correctly and it's working.

@4TT4CK 9 ай бұрын

cool, i just hooked up my red/yellow wires to the +terminal on a 9v battery and the white to the neg post and the shaft started spinning. guh, now looking to replacing a capacitor and some relays on the main ctrl board. bruh @@funkycowboy

@funkycowboy 9 ай бұрын

@@4TT4CK I figured this was the part, so I bought a china version on amazon and it worked. Then returned it and bought the OEM version.