This video shows how to remove the front bumper cover of a second generation Ford Fusion (2013 - 2020)
Пікірлер: 13
@coolissimo69 Жыл бұрын
Dude great tutorial , 2:28 I was struggling so bad to take it out, didn't use an impact gun.
@stanleyhenry37002 ай бұрын
Great Video, you make it look easy. I have a 2017 Fusion, based on your findings, it should be similar. I need to replace both bumper and fender. Some videos makes it look difficult. Some people remove the bracket that attaches the bumper and the fender. You only remove one screw and some clips on either side. Wow!! Do you have a fender removal video? You earn my vote.
@TheNomadMechanic2 ай бұрын
Thank you for your comments, unfortunately at the moment I don’t have one for the fender removal.
@alanjm12343 ай бұрын
This is pretty easy. Try removing a Kuga/Escape bumper!
@velvetpaws999 Жыл бұрын
Thank you so much, very helpful! I like that little electric screw driver that you use, as well as the red little wrench. Is that one specifically useful for any plastic plugs and such? Thanks again! Well done!
@TheNomadMechanic Жыл бұрын
Thanks for your comments and regarding your answer, yes, the plastic (red) is a generic plastic trim removal tool, very useful and cheap in my opinion. Regards.
@egscomp807410 ай бұрын
The best video on this thanks🙏🏾
@TheNomadMechanic10 ай бұрын
Thanks for your comments brother, regards
@TerryBrown-kq8wl6 ай бұрын
Great video. Thanks heaps!👌👋
@TheNomadMechanic6 ай бұрын
Thank you for your comments!!!
@alexpatience448 ай бұрын
what size is the bolt for the bumper to the wing please.
@luisgabriellelualhati4643 ай бұрын
How did u disconnect the block heater wire im having trouble
@TheNomadMechanic3 ай бұрын
I used a small flat screwdriver to release it, it is a bit tricky