You are welcome

you are welcome.

Tim Watts Cool, thanks for watching.

camillo monaco Glad it helped. Thanks for watching.

+Robert DIY Hello Robert my 960 starts runs rough now it wont start do you think it is my fuel pump it was running fine till I went to gas station put gas in then it didnt turn over well it does but its like stumbling then shuts down

Can you hear the pump running? - kzfaq.info/get/bejne/aaephdOI37HRn6M.html

Michael Sackstein That one was tight.

trunk

Robert DIY thank you. I also just bought some car ramps to get to my filter. Your videos are very helpful!

Man, whatever I say in the video. You may have to break it and get a replacement.

Mega Manski You are welcome.

just in tank

Thanks for watching.

Huh?

Stephane Farley Shouldn't be bad as long as you have an o2 sensor socket. - kzfaq.info/get/bejne/eL-ne7KfmbTMfY0.html

Yes, replaced the o 2 sensor and replaced the check engine light bulb, now driving to clear code,no check engine light. It still says O2 sensor problems... Too many tickets now... Seeking out other help... Thanks... Oh found wires coming out fuse box to under hood,lol

Does the pump work?

Is the polarity reversed?

@RobertDIY pump cuts on just no gas coming out I took it out made sure nothing was broken and it ain't put it back in .nothing coming outta tank to rail its not even reaching filter

I don't understand your question...are you saying that your gas gauge is broken?

yes

You're quick! That's awesome, thank you! I recently purchased a 98 v90 that stalls usually after coming to a stop. RPMs drop and I have to goose the pedal to keep it alive or it shuts down. Usually starts back up after a couple cranks.

@RobertDIY I solved it! The fuel lines are deteriorating amd clogging the fuel injectors.

The gasket should come with instructions. Did you want ANY of my cylinder head installation videos?

the video doesn't show?

@@RobertDIY no it does not,im trying to pull my quick discoonect fuel line but it wont pull off,im pulling up on the sleeve and line but it isnt working i think im doing it wrong

I have no idea. Check a parts website to see if the numbers are the same.

have you scanned it for codes?

@@RobertDIY Thank you ! My wife explained the problem wrong. This is a starter circuit problem . Much of the time and for days at a time the starter starts the car completely normally . Then suddenly ( unrelated to warm or cold engine after 8 hour work shift etc. ) the starter solenoid will just click but the starter won't engage and turn over the engine, leaving you stranded. Then after a few days of rest (idle neglect) it will return to normal operation I have now had a shop remove the starter and I personally have disassemble and reassembled the starter . ( cleaning and lubing , brushes are ok commutator fine sandpapered etc.) And I have bench tested the starter . It seem fine. The shop I had install an after market new $67.00 ebay starter . The shop said it would spin but not engage. Now I want to have them put back the original starter to see how it preforms if the intermittent problem is gone. Thanks for your kind help with this matter Robert Thomas

Sad to say, I do not.

Thanks for your reply

No / yes.

kzfaq.info/get/bejne/erOnkqeYv9vQe5c.html

No

@@RobertDIY Thank you

I don't understand your question.

I don't understand your question.

Fuel cable?

Thanks for watching

Would you like a refund?

zx8401ztv LOL

What issues do you have?

Robert DIY my 95 960 was sluggish , the coil pack wires were brittle shit... u seen em.... i cut snd may have wired wrong but have according to schematic, and it wont strt everything fuel is wirimg ir no signal according to self code checks cnt check ignition codes

Gas pedal real fast on crank sounds closer to a start but not there

kzfaq.info/get/bejne/j8-AdLOmkrGcf30.html

Robert DIY its not my fuel pump... checked in hand

+Christian C how did it go?