Awesome video thank you. Great advice also.

You did it. Tank U very much 👍👍👍

I have nissan naavara d40, my problem is that after traveling for almost 40k my truck begins to lost power and emit black. I have cleaned fuel tank, change fuel filters but still the problem exist..thanks for any advice...

Hi, near the SCV is a wire connection , what sensor is there , i have the connection but is not connected to anything

my nissian x trail is not starting its coming up low rail pressure could this be the problem

Thank you

My np300 yd25 engine will get a little bit stuck on rev 900-1100 and rev slow and after that it will do perfectly... When driving when going over a bump and the rev goes below 1 especially on gear 2&3 it will rattle also when when loaded on a small hill it will rev down and will turn off forcing me to use 4wheel drive high what could be the cause and how can I resolve it? Thank

Good advice.

That's what my Nissan navara problem is

I got my scv of ebay for 35usd. In 2018.

Clean fuel tank☺

i have my nissan navara yd25 d40 it only cranking but not starting ,but if you do hard push it starts well.i took injectors for service and clean fuel tank but the problem still remains the same what might be the problem

Can i ask why my nissan navara sometimes dosnt go up to 3 abortail what is the prob i put a new injectors i changed the old one and again i have problem with power aometimwa goes good sometimes stops please help me

Hi guys, I have Navara d40,2010, we replace clutch and after that rev not go above the 3000. Attached the scan tool it’s shows code PO335, crankshaft position sensor ,any idea to solve this issue, please advise me. Thanks

Good video buddy

hello, i replaced fuel flow control valve, remove fault with computer, but after test drive same fault occurred and same things happening, no power etc, where to check whats wrong?

hello i have an pathfinder 2006 also without DPF, i have no error on the tester but it does not make pressure on the intake, it has a very low vaccum pressure in the pipe that enters the selenoid sensor, i verified the pipes, there are ok, can you tell me what should i check next ? Thank you !

Why not show where the suction control valve is on the motor

we a nissan np300 2.5. the vehicle has no power but if you switch off and on whilst the vehicle is in motion it will perform back to normal but the moment you brake the vehicle will loose power again. the diagnosis came and said the pump needs attention.

Hey buddy. Where can i find that EGR cooler.

Hello. I don't have a car speed. How can this be?

My 2009 Navara goes into limp mode when I set off quickly. It shows high pressure system fault code. Other than that there is very little power at low revs until 2500. Hill starts are nearly impossible. Once over 2500 revs it flys along no problem. Could this be a valve issue too??

876 peugeot 206

Thank you. I was ready to throw away my car

Where that part go?

Only a matter of time before that Navaras timing chain snaps, why bother 😂

I can see a lot of different car with denso fuel system, have same problem Company's should refuse using their systems, they are crap

You're explaining to tech people. Try to explain to users

$40 on ebay

kzfaq.info/get/bejne/ieCTg9BjvsrQZWw.html

Blah blah blah n even didnt show the doing job!

P

Like n sub yol

I hate DENSO so much

you don't show how did you take it apart??