In this video, I show how you can make hems (or Safety Bends) in Sheet Metal since there isn't currently a Hem command. There are many different tips thrown in this video, so make sure you watch!
Пікірлер: 19
@ScottDube1Ай бұрын
Brad good video! Couldn't you create a new sheetmetal rule with all of the settings rather than going back to the 3 dots each time?
@bradtallis8968Ай бұрын
@ScottDube1- This is a great idea. It would help with the Bend Radius setting and the Seam Gap setting. However, you would still have to enter in the bend angle and you would have to verify the thickness of the material. For example, if I created a rule called "Hem" and the material thickness was set to 0.1in and then I applied that rule to my 0.25 thick sheet metal part, it would change the thickness to 0.1. However, if all your material was the same thickness, your idea would definitely speed up the design process. I'm going to pin your comment since I think it's a good idea. Thanks for sharing!
@ScottDube1Ай бұрын
@@bradtallis8968 I try to have a rule for each thickness.
@dalecollison791Ай бұрын
Great tip Brad. I use that style of command all the time but I just did a 90 degree fold and tell the guys to fold it right back. Now I can actually show it as a safety edge! Brilliant 👍
@bradtallis8968Ай бұрын
Glad I could help.
@johnb6599Ай бұрын
Brad, I have been building stainless steel battery boxes for light aircraft for several years with .032 stainless sheet using this fold over bend to strengthen and eliminate the supper sharp edge. I have tried to use fusion to design them but have never figured out how to do exactly what you just showed in this 7.5 minute video. Thank you so much and I am heading to Fusion to get started.
@bradtallis8968Ай бұрын
That's great! Thank you for sharing your example of how you are using Fusion. Thank you for watching.
@learnitalreadyАй бұрын
Excellent tutorial gain Brad! Much appreciated.
@IceCreams62Ай бұрын
Very appreciate Brad. Have a nice time during the weekend 🙂
@bradtallis8968Ай бұрын
Thanks, @IceCreams62
@longbeachcitycollegemetalf3321Ай бұрын
OMG, Thank You for this! I have been doing this the HARD way for too long, and my life just got simpler. :)
@bradtallis8968Ай бұрын
I'm glad I was able to help!
@BlackSmokeDMaxАй бұрын
Some great tips here! Thanks Brad!
@bradtallis8968Ай бұрын
You bet!
@stephengittins6116Ай бұрын
Great video Brad. Everyday is a school day. 🙂
@bradtallis8968Ай бұрын
Lol. Thanks for showing up for school!
@KabilProgramaАй бұрын
Nice! Thank you
@RobinFöreАй бұрын
I cant see why fusion 360 cant implement hem function as inventor has. Must be a requested feature now for at least 8 years?