Here's a great tip that really works good. Been designing lawn sprinklers for years. If you connect the opposite end of pipes from valve end together, you will have exact same pressure in every watering hole in pipes. Can fine tune system. Remove caps and install tees or 90s with little extra pipe.

The music had a cool beat and was easy to dance to.

This system is working great and has simplified my watering.

Great set up!thanks for posting.being a plumber for many years,I feel the uncontrollable need to let you know that when your glueing pvc of any size always glue the hubs first,they dry at a slower rate than the stick of pvc itself. I know it’s trivial but if something unforeseen were to happen to slow you up connecting the fittings,it would buy you a little extra time to get things together. Again great video thanks.

My kids would have a blast playing in that sprinkler system... Thanks for sharing!

Invest in a set of ratcheting pipe cutters if you're cutting 1" PVC or smaller. Much easier than sawing by hand, and no plastic "sawdust" to clean up!

Great in formation thank you sir

great video. i will do it

I've been considering a similar system but as a gravity flow system from a tank I collect rainwater in from my roof. Don't really understand why you'd use it with a pressurized system when you can use a sprinkler.

nice

ye music would put ye mad , could not take things in, other than that, would be good , good work to ye Sir, looking good thanks

если зарыть в землю, всю эту систему, на 35-40 см. получаешь меньше проблем с сорняком (до верху не проливаем) и меньше используется воды для полива, значительно. Да, и нет корки на поверхности грядки. Мульчируем сосновыми иголками и песня!!!

Hey, thanks for this video. I had a couple questions. What diameter holes did you drill in your tubes? In retrospect do you think that size worked well? Did you line the holes up, or stagger them back and forth a little off an axis? What was the issue you had with the main connection leaking under pressure? I presume you glued and Teflon taped where applicable - what went wrong there? Also, you have a notch in your otherwise rectangular garden shape - are you planning to put something there? Why the indent? Thanks again for the sharing!

beautiful music

Can you reach the middle of this bed to harvest?

How many of the PVC pipes will your hose run at one time and are they 10 feet in length? Thanks, very helpful video!

Hey have you ever used leftover bait as compost it works great

that nice video , i need quick help here , i was designing same project here but the difference is that i only have two rows where one line comes and splits to two side left and right side in the middle and the one waters half of the width the (left side )and the other half (right side) the width here is 1 meter and the place is about 20 meter long i used 3/4 inch PVC pipe . my question here is i want the water to spread evenly over the area and reach all the 20 meter long . what conditions should i consider to make that happen and what size of hole should i drill , how about the spacing between the holes i really need your help i am just an electrical engineer and dint know my way on water flow and everything. tell me what to do and consider . i appreciate in advance

This is exactly what I’ve been looking for! About how much did it cost to make and how well did it work for you?

Thanks for the video, but with information videos, any kind of background music is a distraction. What I have found on my attempts at PVC irrigation systems is that the holes closest to the water inlet dispense plenty of water, but the far ends do not.

Turn the music off

great video! how much water comes out of a hole in one hour? have you ever measured it? not when the holes are flowing fast but when they are dripping slow. please reply.

What size of drill bit do you used for making holes

Kreatif

What have you learned from this system?

Billof Rights, What is that little tune you have playing? I think it's pretty awesome. Do you have the title or a web link? Thank you. Also great project. Thank you for taking the time making it

What size holes did you drill? What was the spacing on the holes?

can you send me a copy of that music? I want to use it at my next fiesta. LOL

what soil do you use?

That’s a lot of ball valves, why wouldn’t you just use the 1st one or maybe 2. Seems a bit excessive

hell of a lot more work than just a regular system with a valve and a few pop up heads.Weird.Music is sooooo horrible

music is distracting , annoying and unnecessary.

WOW, all that?!?!? When you could hook a sprinkler to a hose and water that whole garden at once????????????? Maybe he hasn't heard of "sprinklers"??

Your music ruins this video.