Gas Cooktop DIY Install - Biggest Common Mistake!

Рет қаралды 22,463

10 ай бұрын

Connecting a gas cooktop, oven, dryer, appliance flex hose the proper way! Here's how to properly seal the connections..

Пікірлер: 17

@q3huynh 3 ай бұрын

Thanks for the video. Good tip as i was putting in my new cook top.

@Lastdon56 6 ай бұрын

One of the biggest rules of installing gas piping or appliance connectors is that whenever you screw metal to metal to a line that will be delivering gas with no thread lubricant, 10 times out of 10 it WILL leak. It's just a matter of time.

@berniecarter4049 10 ай бұрын

As per the instructions and the fuel gas code, a valve is also required before the flex line.

@TechCloset 10 ай бұрын

The valve for mine is located in the cabinet to the left of my cooktop.

@1mrsleepy1 5 ай бұрын

Everything except flare fittings my boi!

@timlarge8927 20 күн бұрын

Where is the shut off valve on the gas line? It must be located in the same room and within 6 ft. of the appliance.

@TechCloset 19 күн бұрын

The shut off valve for the gas line in this video is located about 2 foot to the left inside of the adjacent cabinet.

@Dave-ld3dr 7 ай бұрын

I have to hook up a new gas stove.Can I reuse the fitting going into the stove?The 1/2 to 1/2 flare to the hose.

@TechCloset 7 ай бұрын

No, you need to replace the fittings and the hose every time you hook up a new appliance. That’s why they sell them in a kit; they are not designed to be used more than once and it’s really not worth risking it.

@kdbwiz 4 ай бұрын

What about on the male connector of the valve? Sealant there or no? Is gas pipe thread sealant tape ok to use where sealant is indicated?

@TechCloset 4 ай бұрын

I’m not an expert, but in my opinion yes you can put pipe dope on the gas valve male connector. Just don’t put it on the connectors for any flange style fittings like I show the video. The “pipe dope” sealant is stronger than tape and designed for permanent connections under pressure. As far as I know plumbers use the pipe dope sealant for gas connections and some even use both. Personally I would not use the tape for gas connections.

@jasonyoung4890 4 ай бұрын

Gas PTFE tape is ok right? That's what I used when I added a shutoff

@TechCloset 4 ай бұрын

Most plumbers seem to use pipe dope, no tape. I once had the gas company for my city come out and do a repair. They used pipe dope not tape. Use that information as you want because I’m not an expert. Both are probably fine, but it seems that the “professionals” don’t use the tape.

@timlarge8927 20 күн бұрын

If you have a plastic threaded connection and you use pipe dope you have to read the instructions on the tube/can of the pipe dope to ensure it can be used on plastic. NOT ALL PIPE DOPE IS APPROVED TO BE USED ON PLASTIC. If you use pipe thread tape for gas you must use the yellow teflon type tape. The white teflon tape is not approved to be used on gas lines. I am a retired inspector and have rejected hundreds of inspections for these two simple things.

@TechCloset 19 күн бұрын

Yes, the pipe dope that I purchased is clearly marked “for plastic and metal pipes” on the container. Thanks for the information.