No video
Getting a Willys L-134 running after sitting for years
Рет қаралды 1,044
Күн бұрынUse code REDEYEGARAGE10 to save 10% of your entire order from www.kaiserwill...
Installing valves in the L134 G0-Devil willys engine. Here is a brief rundown on all the parts I have on hand to bring this poor old relic back to life. Below is a list of all the items in this video. Follow along to see more of this process! Feel free to ask questions and thank you so much for watching!
Engine Overhaul kit:
www.kaiserwill...
Starter:
www.kaiserwill...
NOS Connecting rod:
www.kaiserwill...
12V coil:
www.kaiserwill...
Distributor:
www.kaiserwill...
Water Pump:
www.kaiserwill...
Thermostat:
www.kaiserwill...
@clinthutcheson2640 2 ай бұрын
Thanks for your videos! Putting together a 1965 CJ5 and you have helped me so much. Rebuilding my Dana 18 tomorrow!
@redeyecafegarage7484 2 ай бұрын
Awesome! I’m glad the videos have helped. Thanks for the feedback.
@187manowar 3 ай бұрын
Also May is almost up. Step to it.😊
@redeyecafegarage7484 2 ай бұрын
I know right! Haha. It’s getting down to the wire
@amx19733 3 ай бұрын
Wow that was satisfying!!!!
@smoothiejankins 3 ай бұрын
Tease!
@dwaynetyrrell3128 3 ай бұрын
I have a chain drive motor in my 3 a not sure what it came out of looks like a star stamped in it!! Thinking maybe a welder or perhaps a generator but she seems to do just fine!!
@187manowar 3 ай бұрын
You should try to find that jeep manual as a digital copy. Just so you always have one you can look at on a phone or something.
@redeyecafegarage7484 2 ай бұрын
There may be something out there. 🤷♂️
@died4us590 2 ай бұрын
Where did you get the valve spring compressor, looks perfect for these engine's. I have that manual, and two for the m38a1, i really like looking through it, something about it being paper, and my jeep being that old. G-d bless.
@redeyecafegarage7484 2 ай бұрын
It’s an ancient k-d tools Flathead valve compressor. You can find them used.
@markbarnard1399 Ай бұрын
If you were not doing any machining, did you sand the top of the engine and the bottom of the head?
@redeyecafegarage7484 Ай бұрын
No, I would never recommend that. That will only further reduce flatness. All you want to do is clean the surface.
Halfass Kustoms
Рет қаралды 1,4 МЛН
Shit Show Off-Road
Рет қаралды 233
Pacific Northwest Hillbilly
Рет қаралды 2,9 МЛН
Jim's Automotive Machine Shop, Inc.
Рет қаралды 295 М.
NoNonsenseKnowHow
Рет қаралды 2,8 МЛН