2011 V6-3.0L GMC Terrain goes into Limp-Mode while driving. Engine Power Reduced and check engine light comes on. This video shows you how to repair this problem.
Пікірлер: 63
@mariocuadra18264 жыл бұрын
Wow that is one good demonstration video for as you DIY warriors out there. Thank you Nicola for another helping hand.
@InitechAuto4 жыл бұрын
My pleasure!
@LakissaJ2 жыл бұрын
I have 2015 GMC Terrain and my suv is now jumping when i stop or when i turn it off.. But no noise. Only when it shake...when i stop at home. Timing Chain solenoid
@daviddiaz34442 жыл бұрын
Thank you very well explained.
@markchapman2585 Жыл бұрын
I need to this and wheel bearing on my dad's 2012 GMC terrain such a pos. Got it new and had the engine rebuild with 75,000 km it was under warranty. But great video thanks for the post. Cheers from Canada 🍻
@jasmineash22642 жыл бұрын
My 2013 GMC Terrain is saying engine power reduced with stabilitrak light and engine light. I have replaces the throttle body and spark plugs and it’s doing it once again I feel defeated. Could you point me in the right direction?
@InitechAuto2 жыл бұрын
What engine codes are you getting? Make sure you clear them and see what comes back. Also check the wiring. And just because the throttlebody is new doesn’t mean it’s good. Verify your work
@zuccetcontreras46332 жыл бұрын
Same thing is happening to me, have you found a solution?
@love005212 жыл бұрын
Same to me have u found the solution ?
@ccierralou10 ай бұрын
I have a 2014 and mine is currently going this I had replaced the whole throttle body and crankshaft and cam shaft sensors and still doing this was told the timing chain. is ordered . Any ideas if that maybe work or an issue they may have over looked?
@InitechAuto10 ай бұрын
Wow! thats alot of parts changing for that code. You need to follow the trouble tree for that code. Sounds like a lot of guessing. You can't do that. Take it to a good shop or dealership.
@timrowe284 жыл бұрын
Have a 2010 GMC Terrain SLT V6 . At first track control light came on for awhile then would go out , now have a service all wheel drive lite on all the time . Any ideas what the cause could be . Vehicle is low mileage 80 km not driven a lot .
@InitechAuto4 жыл бұрын
Try scanning for codes and reset. Check wheel sensors.
@timrowe284 жыл бұрын
Nicoya . OK I'll try that. He did take it to a Canadian tire and had it scanned but they said they couldn't clear the code and it had to go to the dealer cause their scanner couldn't clear it or something like that. Which didn't really make sense to me. So I'm gonna take it over to the shop I work and see if I can't figure it out
@richardromero1736 Жыл бұрын
The problem is you're wiring that goes to each wheel speed sensor You need to cut it back about maybe two or three feet each wheel and see where the break is they dry up and the oil gets in them and they break and you need to buy the wiring harness for it's probably better just replace all of them
@richardromero1736 Жыл бұрын
Probably need to keep up your wheel alignment
@Hajar234564 жыл бұрын
I have problem with check engine = i have terrain and when i start the key in on postion there is no check engine light !!! and i cant start the engine
@InitechAuto4 жыл бұрын
I don't understand the question? Are you saying that your check engine light will not come on? If so, check fuses. Make sure you have power to the PCM.
@Hajar234564 жыл бұрын
@@InitechAuto yes this my issue, however, I'm sure all fuses ok and the PCM already have power
@Hajar234564 жыл бұрын
Because the vehicle had a workshop that did not know how to repair vehicles, and he tried to repair the vehicle, and he expected that the problem was from the fuel pump, and I had a problem that the fuel gauge was not working, and then I had a problem mentioned above and the vehicle became unable to start and unable to check because there is no check engine light
@InitechAuto4 жыл бұрын
@@Hajar23456 All I can tell you is this. Try to communicate with the PCM with a scanner. If no communication, check for power at pin 16 and for ground at pin 4 and 5 at the OBD II connector.
@kiaranicole65082 жыл бұрын
2014 terrain, changed the throttle sensor and now my truck keeps idling and starting to shake a bit, what to do
@InitechAuto2 жыл бұрын
Check your work. And also check for any misfires
@darwinjoya9890 Жыл бұрын
Yo tengo una pero tengo un problema de engine reduced pawer pero no me aparece ningún código 👩💻
@ezrajohnson72572 жыл бұрын
My sisters 2015 GMC Terrain and she just had a p0412 code pop up on her gmc app it says “Air bypass solenoid harness open or shorted how can I fix this
@InitechAuto2 жыл бұрын
Pull up the wiring schematic to the circuit involved and perform pin point test to find out whats wrong.
@ralphwhitaker8761 Жыл бұрын
I have a 2011 gmc terrain, last night my engine stops completely and the message came on power engine reduced, can it be the same problem with throttle body, I parked the car and haven't try any thing because all shops are closed today
@InitechAuto Жыл бұрын
Connect a scanner and see what codes you have.
@ralphwhitaker8761 Жыл бұрын
@@InitechAuto I just did and it starts with a message " service stability track" I just went to Wal-Mart to buy a cheap obd2 scanner, it is reading 5 codes: P0014 B camshaft position timing over advanced P0302 cylinder 2 misfire P0325 Knock sensor 1 circuit bank 1 P0420 catalyst system bank 1 P228D DTC definitions not found to refer to vehicle service manual Its raining like hell there is not much I can do outdoors, so I'll let it rest for today, but any suggestion will be greatly appreciate before heading to a mechanic shop, thanks
@InitechAuto Жыл бұрын
@@ralphwhitaker8761 Clear the codes and see what comes back. DTC P228D Fuel Pressure Regulator Control Performance - High Pressure. See if you can check your fuel pressure. Does the vehicle restart after codes clear?
@ralphwhitaker8761 Жыл бұрын
@@InitechAuto okay I did what you said, it starts I took it for a spin for about 15 minutes and still running, now I am wondering if I can take it to work tomorrow
@InitechAuto Жыл бұрын
@@ralphwhitaker8761 Just take the scanner with you. Hopefully while driving you can isolate the problem.
@mckinleywilliams99467 ай бұрын
Can you still drive your car when it says engine power reduced
@InitechAuto7 ай бұрын
Not very fast. I would not drive it.
@juliocesarmartinez33457 ай бұрын
You the man
@jusbeyouplease52542 жыл бұрын
Awesome video
@latrishareed40822 жыл бұрын
So does this go as the Powertrain system sensor
@InitechAuto2 жыл бұрын
I don't understand the question? Do you have any engine codes?
@kyannpepper1004 жыл бұрын
Question: when there's a problem with the throttle body can the car shake as well
@InitechAuto4 жыл бұрын
I would say no. Unless you have a misfiring engine as well. Check the PCM for misfire codes.
@kyannpepper1004 жыл бұрын
Nicoya what about the MAF Sensor?
@InitechAuto4 жыл бұрын
@@kyannpepper100 MAF sensors generally cause stalling type symptoms. Stumbling feel. Which can be tested with a scanner. You can even try unplugging it and see if the vehicle runs better.
@kyannpepper1004 жыл бұрын
Nicoya would that throw the engine into reduced power mode if it's not working correctly?
@InitechAuto4 жыл бұрын
@@kyannpepper100 That's a very good question! I would say no.
@bigboy501720153 жыл бұрын
Do you have to reprogram it or get it to relearn
@InitechAuto3 жыл бұрын
No, Just drive it.
@user-ch1yy3wn8r7 ай бұрын
How do you clear the code?
@InitechAuto7 ай бұрын
After you do the repair, you clear, the code with a scanner
@gonfitsemere70153 жыл бұрын
I have problem my car vaxwall corsa 2016 model power reduced Engine how to fix please if you no late me now thanks for the program 👍
@InitechAuto3 жыл бұрын
No idea
@manuelhinostroza64622 жыл бұрын
Cómo puedo pagar bolsas de aire
@InitechAuto2 жыл бұрын
Hay que reparar el sistema de bolsas de aire para que se apague la luz.