This guy deserves a cameraman.

Thanks for the video. I did a similar but simpler fix to get mine working again. MUCH quicker than removing and reinstalling the motor 1. The location of the motor is up under the glovebox. My car had a foam flap with a single holding screw which had to be removed first before what you can see in the video is apparent 2. The issue was the teeth on the gears had jumped (due to a stone in the flap), so like in the video the motor could not turn fully 3. Set the car temperature to full hot or full cold 3. A simple fix - pull the gear that drives the flap out just 2mm so the teeth no longer engage. 4. Then rotate the gear so the flap matches the motor either full hot or full cold. (The spindle will keep it locked to the flaps when you rotate it) 5. Push the gear back in so it re-engages with the teeth and clicks into place 6. Re-calibrate the heating and cooling. Now when you adjust the car temperature, the gear and the motor should rotate through the full range of motion and not get stuck Much quicker and easier than this video

The restrictor broke what stops the gear from spinning itself out. put it back and works good 👍🏼 thanks for the vid

In my 2018 Tiguan the heat and ac seems to work okay but sometimes you hear "Clack, clack, clack, clack" from under the dash on the right side of the car. Sounds like this gear slipping while trying to drive the damper. Same issue you think?

Hi there, nice video but i was wondering, i took out the one u took out from the car, i put the connector back in to ser if it goes around, it did. But the car is still blowing cold from the passenger side. Would appreciate feedback on that, what else could it be?

Can you make a video how to change air distribution flap control motor V428 on vw golf 7?

Did he change The motor or only out and in Again

Спасибо!

Very good! Thank you

i have clima manual no bizone and missing white flap on on right side below . it is normal? moreover when switch on high temperature i have only warn air on left side while on right not ,it is seems tepid what happen????

thanks for the video

Jesus. I'm tiny and can't even imagine being able to maneuver this.

did you use a TORX t20? How did you change the key? Mine can't turn, it' s impossible! Thanks

I am trying to find where is located this part in Audi A3 2002 BFQ. If u know let me know plz.

Hi. I have a 2016 Golf Mk7 GTD - I have noticed that the heater doesn't blow cold or hot air in the footwells. Any ideas how I could resolve this? Appreciate any help... Thanks

Hallo ich habe fast dasselbe Problem ich habe einen Golf 7 kombi bj 2016 mein Problem ist ich bekomme links und rechts kalte luft also die Klimaanlage funktioniert aber in der Mitte kommt keine Luft mir sagte man dass der stellmotor defekt sein ist dass der selbe Fall wie im Video und wie lange dauert es uns was würde es kosten in der Werkstatt vielen Dank

Does it cause a cold air always blowing on windshield

Thank you!

cool

zdravim mám ten istý problém odkiaľ ste vedeli by ste sa nato pozrieť ? dakujem

I have this error: "329220 Fault in motor for air distribution flap B109D 71 [009]. actuator stuck" it could be the same piece to change ?

Mine on a vw golf 16 plate and i cant see it either side ideas anyone? 16tdi dpf model

Does anyone know a video showing the replacement on the left (driver) side?

to najstavenie studenej pozicie sa neda urobit aspon v mojom pripade nie, dolezite bolo to dajako nasmerovat aby ten stredny vystupok zapadol do tej bielej medzery co otvara klapky , takze podla navodu sa neda postupovat uplne

Ahoj. Nefunguje mi kurenie, podla PC je chyba v module. Ale ked som vyzualne kontroloval tak pekne zasadne polmesiacik do zarezu a klapka ide na hot a takisto spät na cold. Ked dam ma max teplotu tak ide jemne teply vzduch...

Tiguan 2018, same work?

😊😊😊

Zdravim prosim o radu mam golf 7 rv.2103 a chladi len ľavá strana pravá fuka teply vzduch mize to biť tento diel vadný? Ďakujem

Whats the part number for the motor/control unit? thanks

Ahoj potřeboval bych poradit. Mám vw passat b8. A do zadu vůbec netopi čím to?

I replaced mine I’m still not getting hot air ?

this for flap flow right side only? there is another one on left side ?

Mine doesn’t even have a module there.

328197 - Motor for Right Temperature Flap B108D 54 [009] - Missing Calibration / Basic Setting Confirmed - Tested Since Memory Clear Freeze Frame: Fault Status: 00000001 Fault Priority: 2 Fault Frequency: 1 Reset counter: 57 Mileage: 142022 km Date: 2022.05.26 Time: 12:06:47 Voltage terminal 30: 11.7 V Outside temperature: 34.5 °C Inside temperature: 43.9 °C Right temperature flap: actual value: 0.0 % Right temperature flap: actual value: 15 Temperature door right - Specified value: 15 i have this one , do you mean that is the same motor flap ? (try to calibrate but same error show)