Brian you’re the peoples champ for posting these videos and helping us contractors out. I’ve got a 650 as well and love it! It’s having some issues holding pressure above 3000 psi I hear a small whistling sound near the prime valve / fixed fluid hose but I never have the pressure that high normally so OK for now. Was told by graco to do a hot water laundry detergent flush of the system so will see. Keep on rocking man !

You are a fucking life saver! Machine was fucked, have a job on the 2nd January... Of course everything is close now with the holidays. Thank god!

Thanks buddy , you save my a$$$ for tomorrow morning thanks again

Excellent presentation, thank you!

Successfully repacked my machine that wasn’t priming thanks to your great tutorial. Sleeve was good, but noticed paint inside of the packings this a sign that seals are failing right? The black plastic snap on cap that goes on top of the piston locking nut was broken, maybe that caused paint to leak into packings. Where can we send donations to ? I’m so grateful for your help !

Thanks great job,looks like u done that before lol.It's fun too watch a pro

Thanks!

I like Titan more if i see the inside of the pump section from Graco. The Titan Block with manifoldfilter is great.

Wsup mr Brian

Hi Brian， great video. I have the Graco 650 bought last year, recently it just keep losing pressure when I spray , the machine keep pumping but no pressure, sometimes is good sometimes is not, do I have to repack the pump? Any suggestions? And What kind of kit I need to buy ? Thanks a lot.

Nice video! I have a 650 that requires a new "Cylinder Sleave" do you have a place I can easily buy one? or know what size I need? I've had to replace the cylinder sleave twice now in the last year.

Quick question Brian, when tightening the packing nut does it always have to go down enough to make the oring contact the cylinder? Asking because repacking a 1095 I had to go well above the 100 in-lb recommended in the manual to bring the oring down enough to be touching the 2 parts. In other words….does the o-ring have to be pressed between the 2 contact points regardless of the torque needed? Thanks in advance

Have you heard good or bad things about tritech sprayers am looking for a good sprayer for all types of paints blockfiller .dryfall. . Was thinking about either a tritech 8 or 9 or a 695 graco .. what would your thoughts

how are you my friend. I brought a Graco 390, but there is a difference in the electricity 110 / I have 220 electricity. Can you tell me what parts should be replaced?

Good video. Do you know of an effective substitute for Graco TSL that you could recommend? I have a Graco 490 PC II Pro and given the throat seal is to be used daily, and the cost of TSL is not cheap, I'd like to use something more economical.

Hello Brian, I have a Graco 5900, but The gas engine works perfectly, but when I turn on the control box to start sucking paint, it shuts off. What could be the problem?

I have a 650 and it won’t keep pressure I checked all the filters and the down spout I tried replacing the transducer and it won’t build pressure