#Crown_vic #Sway_bar #Bushings Sway bar bushing Part # F4AZ-5493-A Sway bar link Part # F8AZ-5K484-AA
Пікірлер: 14
@IEatMedia9 ай бұрын
Thanks for these great videos! I will be doing the same procedure soon to my Crown Vic
@WhoKnws Жыл бұрын
Another great video
@tyrikmoore3Ай бұрын
I need the video for when the bushing studs start spinning
@rxmarlo2303 Жыл бұрын
What size is the bolt nut on bottom swaybar link? Mines just came loose
@vmans4374 Жыл бұрын
Hi Ahmed did you use motorcraft parts for your sways and ball joint replacement
@ahmedaltowaileb Жыл бұрын
Hi, for the ball joints, yes I used Motorcraft For the sway bar, no
@WhoKnws Жыл бұрын
Moog is a great brand too
@lawofliberty3517 Жыл бұрын
I have a stud that free spins and allows the sway bar to move. Cant get into the frame to hold and or replace studs.
@welfareorphan Жыл бұрын
Mine did the same so I used a Dremel to cut it off.
@lawofliberty3517 Жыл бұрын
@@welfareorphan after buying new bushings, I took the old ones off, the adjacent bolt came out and the stuck one fell out when I wiggled the bushing.
@welfareorphan Жыл бұрын
@@lawofliberty3517 my bad. I was talking about the sway bar links. Thanks for the heads up too because I'm doing the sway bar next.
@lawofliberty3517 Жыл бұрын
@@welfareorphan did my endlinks earlier this year. Upper & lower ball joints, shocks all around, sway bar bushings have been done also. Rides noice now. Going to save up for a complete ADTR suspension kit and do it next year hopefully.
@welfareorphan Жыл бұрын
@@lawofliberty3517 my lower ball joints were bad. I took them off and noticed both upper and lower control arms bushings were bad. So instead of pressing out the joints, I'm taking off everything. I already bought TRW upper joints and sway links. I had the TRW lower joints but sent them back and decided to get all TRW upper/lower control arms with the lower joints and bushing already pressed in. My tie rods are ok for now.