Grasshopper Tutorial Parametric wall

Рет қаралды 20,626

3 жыл бұрын

Contribute to the channel on Patreon, This will get you access to ALL Final Grasshopper script, Rhino models among other advantages. / 3dbeast
in todays project we will re create something like parametric wall concept from Elis Vathi
_________________________________________________________________________
How to model Harbin Opera house • How To Model Harbin Op...
HOw to model Hedar Aliyev Center ZahahAdid
• how to model Heydar Al...
How to model Galxy Soho Grasshopper • Zaha Hadid Galaxy SOHO...

Пікірлер: 16

@faleravanbalen8175 2 ай бұрын

Thanks a lot for this!!! You’re a legend, have a wonderful day🌱🌿

@aminekieffer3041 3 жыл бұрын

Incredible job! thank you so much!!

@3DBeast 3 жыл бұрын

Thanks Amine

@victoriacoppola7506 3 жыл бұрын

Amazing! Can I create this into existing walls surfaces of a model? or should I create a planar rectangular surface and then, once is baked, I do FlowAlongSurface in rhino to attach it to the wall I want?

@3DBeast 3 жыл бұрын

to use on existing wall/surface u must adjust or change some nodes /example use normal to move points like at 2:08 and other that cause problem from vector directions / or u can use FlowAlongSurface as u say , u can also do morph along surface on grasshopper before bake it.

@mojtabamirzaei5294 3 жыл бұрын

great

@3DBeast 3 жыл бұрын

Many thanks

@rommel_e_romero_alva 2 жыл бұрын

holy cow

@jbx6862 2 жыл бұрын

Hello loved the video ! I was trying to follow along but when i connect the u count (27) with the u count input of the surface from point node, it gives me an error saying ( the ucount value is not valid for this amount of points. ), knowing that i followed you step by step with the exact values . can you help ? or if possible share with us the grasshopper file . thanks !

@3DBeast 2 жыл бұрын

Hello, all u need to do is right click on "U" then exspretion and add x+1 If u want the gh scrip u can send me email tridbeast@gmail.com

@jbx6862 2 жыл бұрын

@@3DBeast yes i did add the expression too but it still does not work... thanks !

@user-nh2nk2ty3x Жыл бұрын

I have the same problem. How did you solve the problem?

@k-money2752 10 ай бұрын

is there a way i can make the curves act independently of each other? So some could be higher than others, etc.

@faleravanbalen8175 2 ай бұрын

In the very beginning of the script when you specify the curve, you can add another curve component with shift into the pull point component. Than in Rhino with gumball you lower the base location. Late answer but I hope it helps🌱🌿