You're right! We are making a commitment to be better about this in the new year. Thanks for your feedback!

Why don't you enlighten us with your wisdom?

@@timfischer most back stops are not perfectly positioned 76 feet away from each other you need to find the center line first either center of the volleyball standards or measured from scratch and punched before sanding . measuring the center of the backstop is not needed, using a laser and lever or jig with plum line from the center of the rim is where all measurements come from the back stop is 15 inches below that and the baseline is 5ft 3inch below it to the paint this center from the hoop is also where you place the pivot for the 3pt arc and where you line up your string line or laser to run across length ways to see if the hoops are squared to each other I’ve seen them as far as 4 inches off. a proper examination of the hoops and making sure they are lowered down all the way are needed before any measurements can be made. This process is not that difficult make sure to double check all your measurements and print off a detailed blueprint of the floor with numbered steps for each measurement as well as all the double checks along the way, make sure to get the proper diagram NCAA floors are different from high school and some state’s league rules are different from each other. As far as the best tape in my experience Scotch blue sharp lines painters tape by 3M is the best.