Hack and Break into a Cryptex

No video

Hack and Break into a Cryptex

Рет қаралды 13,677

Күн бұрын

I forgot my password, but figured out a way to break in without damaging the cryptex!
FYI, Your hands will probably cramp up at some point doing this.y

Пікірлер: 13

@antoniosampson7467 3 ай бұрын

I literally just found one of these on the street. I went straight to KZfaq and found this video. I did EXACTLY as he said and got the thing right open. Thank you for posting this video. It was very helpful for ME. I appreciate it.

@TGehle 11 ай бұрын

Well, there seem to be some differences in production tolerances, because tried on mine and had no success until I dialed in most times 5 of the letters, in seldom occasions I was able to do it by 4 pre dialed. The slight moving of the other end only started by the 5th letter, so I assume mine has been fitted much more tightly. (I know the password, but was just curious how hard or easy it would be)

@jsincoherency Жыл бұрын

But if you can unscrew the end cap, can't you just undo the little retaining screw and slide the whole thing off without solving it?

@DionysusTickler Жыл бұрын

you can

@highlander723 7 ай бұрын

This would have worked but I put super glue in the screw hole to make it impossible to unscrew The end cap.

@GoblinModeKnives 8 ай бұрын

This works, thanks for that.

@highlander723 5 ай бұрын

But wait a minute If he unscrewed the side cap can't he just unscrew the little screws there and it pops right open?

@jourdansmith2509 2 жыл бұрын

question i figure u found ur password after some tries but I'm not able to do it since mine is fully intact, is there some other way to open it

@Forgettings 2 жыл бұрын

yes, so if you have the same model he does the right side pointy bit is actually a screw so you can unscrew it to change the combo if you forget it! Unless you have previously superglued it

@eaupalmbeachkidsclub666 2 жыл бұрын

@@Forgettings Well... that was exactly what was done...

@iWhacko 10 ай бұрын

@@Forgettings Mine doesn't seem to have an endcap that can be unscrewed. or it's on really tight

@edge4910 2 жыл бұрын

Me who doesn't have one but thinks they're cool.

@normlewis1984 7 ай бұрын

THAT.....my friends is the HARD way of doing it! Yes, there IS a lot easier way! However, being one of the FEW HONEST Locksmiths around, I WILL NEVER reveal the easy way! Have fun with this method!