lol sounds like trailer park boys

Starting fluid in the intake or carb, make sure there's gas, and hook a battery charger or some jumper cables to it...

I also have the 250ss and i've never had any problems with it. I the only thing wrong with it is that the speedometer isnt working. I thought it was a loose wire but could it be anything else?

@slipknotnorm deffently recomend, beside the switch, witch cost 5$ to replace, no other problems, even rolled it at high speed and still working A+

@SPAWN662 it sure does, driving in the dark is a blast!

@slapurmommaz id just put best u can find, we just run regular, thats only because we got our own pump

The thing you thought was the amp im pretty sure is your Regulator Voltage Rectifier. and i would fully charge the battery give it a 3 second turn no more than 5 seconds on and rest fr 5 seconds. IF FULL BATTERY DONT WORK CHECK YOUR VALVES.. Move in and ex valves on cylinder head in like your pinching them together , set piston to TDC then move them away till you feel resistance an then back just one line, N screw in tight... each line is called a graduation mark... then I would start messing with the carb if its still not starting. air fuel mix, needle, and maby some jets. All in all a 3 to 5 dollar thing of carb cleaner and a lil elbow grease , and a year or 2 of non stop reserch should fix your problem lmao.. Im curious to know if your cylinder head has any markings on it the top and or mid part

Is it easy to replace a primary clutch and belt on this twister 250??

what store did you buy it at at and i was wondering what is the make of the motor.

thx for reply, not the jets or gas or anything, the ignotion switch wont say in the on postion, theres so much play in it, from the vibrations of riding

um yeah we do have ignition proplems, u can it will run if u hold the ignition on, its fixed now with new igntion switch from the factory

Put the choke on. I have a 150cc hammerhead and couldn't start it for about 3 months. I change the oil, put a new spark plug in it and even bought a new battery bc the one I had wasn't keeping a charge. I went up to the dealership and they told me to try the choke which is located under the passenger seat.. I did that and started right up..

well, they are saying that they key needs to be in a certain position or one pefect spot for the speedo to work, which makes it seem more like a contact problem on the back of the ignition?

check for spark first , don't leave loose leads ungrounded or you cold blow something up. if you got spark then find out if you got fuel......

Have question have 250 hammer head where is conect cable fan my car is no conect

“Flamage” feel like I’m watch an episode of letterkenny

I didn’t know those were made in Canada, now I really want one!

Are you interested in seliing your 250? Where do you ride? I'm also in Ontario and I have a 150.

Put your hand over the air filter to make the fuel mixture more rich.

Does this have high and low beam lights for pitch black forest nighttime driving?

I'm not to to sure, I picked it up from a local Motorsports store that was getting them in. I'm sure if you type in, buy hammerhead250ss on the web, something will pop up for you.

Where did you get this plz reply I'm gonna buy one

it that a locked rear end or does it have a dif? i've been com[aring this and the BMS 250 still dont know which to get

Hey i have a maxxam 150cc and do you think a winch would fit on iif so what brand winch do you have and by the way nice vids i subscribed

hello i am trying to look for that same dune buggy on the hammer head webstie but i can't find it is it the GTS 250

im might get one of them do you recomend one or a diffrent brand

put some ether in it. in Ontario im surprised you don't have a can in your pocket

Dude this is a chinese buggy rebranded , many parts from it are exactly the same as on a chinese buggy , damn the front brakes at 4:40 are 100% the same as on my chinatown 200cc quad but still awesome doe

Although it has IRS the shocks really don't dampen much at all...

From which site u bought your hammerhead ss250cc buggy

hay when u put on ur uni filter how did u get her to not bog down?

:D good luck guys !

what web site can you get it off of

@NewSkoolRednecks Hmm i might want to get get one of these but in america its hard to find the SS and also i really dont want to order from a website cause most of the time there not safe..

The owners manual SUCKS for the hammerhead!!! What friggin octane gas are you supposed to put in it? I'm thinking 90, but is 89 o.k.? Or do I have to go for the 93?

change this Intake Manifold, CFmoto CF250, Honda Helix especially at the junction of the pressure hose tube wants to pull out and loses pressure when you change a turn on and run everything else is ok! I have this and I have been on it only a problem

i would replace the ignition, clean the spark, and when cold starting you put your hand over the muffler. it should start. then you take your hand off of it

AC/VC?

spark plug or empty tank or the engine was cold

you dont have ignition problems. maybe you have no gas in it, or u do and you just have to prime the engine. u can spray starting fluid, brake cleaner, just about anything flamable. u can pour gan directly in to the carbs, too. it is just that the gas isnt in the fuel line so the engine wont run

Hey man mine was like that all you need to do is pull the engine stop button out it gets stuck!!

I ran mine until a head gasket started leaking. I was able to start it with only 30lbs if pressure before it quit

I had the same problem with mine. You need to replace your spark plug first and if that doesn't solve the problem replace your ignition coil

where you buy it and how much?

It might be the battery or a bad spark plug

You should just take out the ignition and put a toggle switch on it and a start button

that being said, yu would assume they are only getting spark in this one position, but when key is turned back to run, they wont have this connection! worse comes to worse, yu could always by-pass the ignition, however they are pretty cheap and easy to install

what yu should do is check the back of the ignition make sure yer contacts are clean, and or put some contact glue on the plugins, then yu should take out a sparkplug, leave it in the boot, and have the igniting side on a clean peice of non painted metal! have someone turn the ignition and someone check for spark! do not touch the spark plug while doing this, yu may have a failing coil! let me kno what happens after yu try this!

plenty of gas in it, it was the igniton switch it got more wiggly as time went by last year intell finally couldnt get the key to stick in the certin "on postion"

Where did you buy that hammerhead in Canada I want to buy one but can't find a place

@xxmattxx15 I have 4 of these, the trannys are good as long as you don't shift wile the back wheels are spinning. Hammerhead Canada went tits up in 2009 though.

They are not made in Canada they are made in China... If you drive them hard they will break.. Often.... Welds are weak if you roll it completely over the cage will absolutely compress (roll to side isn't as bad) I had to reinforce welds on my front struts as the Chinese factory ones where very short and almost tack welds.. Bent a hub broke/bent several bars welds pull away with any force, broken ignition(common problem) I had fun in mine but the suspension is Terrible the shocks although it

Some are good, some are bad. Overall I think they are fine for the price, but I had some major problems with my engine.

You said is made in Canada but it does it start I thought it was it cheap like the ones made in China.

i had that problem with my 150 cc hammerhead ignition, I spent 800 euro getting everything fixed on it, I might sell it and upgrade to a 250 cc, should I?? and where do u get yur extras n air filters and all that stuff, please subscribe

Cud u talk to the person beside u or is it to loud

My mate has one shipped from canada. It's bit rough no lights ect but it's running frames fine motors fine. I'm thinkn of buyin it it's a 250 but is there any way to allow the engine full power? Where or how does its speed governor work so I can remove it? Cause for a 250cc it only Max's out at about 35-40kmph. Whochs isn't very fast. Off-road stuff you'd likely never hit that speed but on roads ect it feels soooo slow

@billiamha thats the problem

Use starting fluid i use it on my go kart and works perfect

FIXED! New Video Link In Bottom Info Bar!

Is it road legal

the 150 has the transmission problem, it slips to much but the 250 is awsome much better

Starting fluid

Where did you get it

clean out your carb or have someone do it for you it should be fine after that. and flush the fuel out of the tank. also a new spark plug. cheers

that'sfresh I have a hammerhead 80t I go on the highway with my Dad it goes almost faster than his 4wheeler

check if there's any gas

Could this fit on the back of a pickup?

try pushing it and then start

Good vid man I want this go kart sooooooooooooooooo baaaaaaaaaaaaaaaaaaaad

@rallysport3 Exactly what i was thinking

you can only see the flame at night, wtf, I have a john deere 317 thats like a flamethrower when it backfires

How reliable is it?

I wanna buy the same buggy u guys got but im cheap as fuck, so do u know what place i can buy one for under 1500$

It's a 300 xrx trail master

nice buggy!..I really like the speakers, if you can shoot me the name of them so i can buy them..thanks

Its the battery

try the battery

These maybe assembled in Canada/USA but is would have been made in and come from China.

starter fluid

It's The choke on

no dat was not kit fox dats uav or ac130

Use engine starting fluid

my was made in Japan and lasted 7 years

The Only chinese buggys you dont get are the custom made go carts

how many times does he say pretty sweet no offense

El los vende

Sounds like they should have bought Chinese at Canadian one wants to fall apart too much

WOW!, don't brag how nice it is when it doesn't even run. I'm going to run my SSR now. My SSR is made in China, but at least it starts every time! lol

ain't got no gas in it............MMMM HMMM

That's not a hammerhead

Same as Chinese gokart. No difference.

pull start it

Immobilizer.......

i have one of these it does wheelies

hahah suckin air, pretty sweet. Flammage, pretty sweet. Shocks, pretty sweet. Hmm, sounds pretty sweet to me! FUNNY!

It could be a decent machine if it was a 4x4 and would start ! Ha Ha !

Thats made in china boys hate to break it to u