excellent, can't beat a bit of old school technology, thanks for showing chaps.

Thank you brother, just pulled mine off for tire replacement and did this too - flawless instructions! Worked out fine.

really a great video it helped me a lot with my Hayabusa gen1 (French model) this procedure works fine with the front wheel :-) but with the rear one there absolutely no enought angle to be give to the spacer for having any chance to push the oposite bearing I had no choice but to weld a piece of metal onto a bearing and was able to remove it easily just one point I was not sure was the grease between the bearing and the seal to have a better protection I put a big layer of grease thanks for the sharing and the great job you did ;-)

Great vid guys and good timing for me, just sent my rear wheel for a powder coat refurb and will need new bearings when I get it back tomorrow, my bike exactly the same bike as yours, a k3 Stealth Limited Edition. Never changed a wheel bearing before, think I'll be able to tackle this job now thanks to you, 🏍👍

Nice instructions! Bearings you had there originally were installed the seal towards the outside, no seal towards inside, wrong way.

Great video, what stand is that you have. Thanks

Do you remember approximately how many miles w were on the bike when the bearings were changed and how is the busa riding now that the bearings have been broken in

Please mention bearing part number of koyo bearings

Hi, fist of all, thanks for the video, very helpfull! can you confirm if the bearing is a 6205 2RS?? thanks a lot