Рет қаралды 57,864
Check out my 2nd channel, TT Racing: / @ttracingyt
Previously, I had invested quite a bit of time and effort into modifying a Creality Ender 5 to have an enclosed and actively heated chamber. The addition of the Bambu Lab X1C to my studio has made the Ender 5 redundant, however, so in this video I remove all of the heated enclosure parts, and fit the Hero Me gen 7 part cooling system.
If it feels like at some times I’m being vague, that’s on purpose. The documentation is thorough but not free, so I had to make sure not to make it redundant. I’d recommend anyone undertaking this upgrade, to pay for the detailed PDF guide at a minimum.
Hero Me on Printables: www.printables.com/model/39322
0:00 Introduction
Hero Me video: • Hero Me fan duct teste...
Hero Me gen 5 video: • Hero Me Gen 5: The ult...
0:45 Ender 5 modification history
Ender 5 review: • Creality Ender 5 revie...
Enclosure and heater: • Ender 5 enclosed lid a...
Linear rails: • Linear rails guide and...
Euclid probe: • Euclid probe: Light, r...
BTT Manta M4A board: • Testing the Pi substit...
1:40 Removing heated chamber parts
3:03 Original electronics case restoration
Manta M4P Ender 5 adaptor: www.printables.com/model/5262...
4:05 Hero Me Gen 7 downloads and documentation
Hero Me on Printables: www.printables.com/model/39322
3D Printing Nerd interview video: • 🌟 Epic 3D Printing Upg...
6:57 Part selection and printing
ABL flat mount remix by FeNi64: www.printables.com/model/3563...
8:04 Installation
11:19 Adjustments and calibration
12:18 Test print comparison
Part cooling torture test: www.printables.com/model/1801...
13:17 Evaluation
14:41 Conclusion
Buy quality and affordable filament from X3D. Buy 3, get 1 free and a free sample pack with every order: www.x3d.com.au
Get Quality Resins from 3D Printers Online. 5% off storewide for Teaching Tech subscribers [Code: tech5]
3dprintersonline.com.au/
Take a look around and if you like what you see, please subscribe.
Support me on Patreon: / teachingtech