Nice work and finish. Why was soffit oversailing the brickwork? They made it harder for you than need be
@sherkhansbrickwork85012 жыл бұрын
Some design issues 😭😭 but I tried my best to make it look nice
@bricklayersworldwithandy62772 жыл бұрын
You have the centre line in the wrong place that's why the cuts are not even either side.
@sherkhansbrickwork85012 жыл бұрын
Thanks for the comment mate....the centre line is in the right place i can assure u that but I told the management b4 the cuts won't be same it was 10mm-15mm difference in the cuts either side and thats over 5m length cut up not a normal small panel
@sherkhansbrickwork85012 жыл бұрын
And also if the centre line was at the wrong place the last brick wouldn't come in the centre like how it is in vedio....that end point of the cut up is the middle/centre of the wall I hope you know what I mean
@bricklayersworldwithandy62772 жыл бұрын
@@sherkhansbrickwork8501 it's not important that the last brick finishes at the point of the Gable its more important that you have even cuts either side, if you was to centre a Herringbone Panel like that in a square opening you would have different cuts either side trust me that's not where the Centreline goes.
@sherkhansbrickwork85012 жыл бұрын
@@bricklayersworldwithandy6277 ok let's say I have done it wrong...how should have I done it 🤔
@sherkhansbrickwork85012 жыл бұрын
@@bricklayersworldwithandy6277 i dont mind to learn if u teach me the right way maybe next time when I do it ill do it right 😌 🤪...
@justycrusty2 жыл бұрын
Nice work. They didn’t make it any easier for you either, soffit should stop at your work