The fell beast aproaches ,quick chat on the model and my paintwork. Hit that like and subscribe for more content
Пікірлер: 4
@ArchangelTyrael Жыл бұрын
How did you place it in the clear stand? The instructions say not to glue it. But I think It’ll be quite wobbly. And did you tape it in during painting?
@hobbyspotnz28335 ай бұрын
I drilled out a slightly larger hole and glued it inside with super glue. I taped it up with paper tape before i undercoated. then i peeled it off.
@jonners6067 жыл бұрын
How deep are your magenets? I'm just getting into using magnets and I bought some which are 2mm wide and 0.5mm deep, but I think that 0.5mm is way too small having just opened the packet and seen them. So just wondering what you used (for width and especially depth).
@hobbyspotnz28337 жыл бұрын
I used a drill bit the same diameter as the magnet and drilled to the depth where the magnet lay flush with the model similar to what you see in the video. hope that helps. any wee magnet will be sweet my only regret is not doing the wings. I would have used 4 magnets on either side to keep them stable.hope that helps