Hold Fast V812 Vacuum Chuck Generator Review

Рет қаралды 876

Күн бұрын

My honest review of this system after several years of use. I did see that you can buy the system without the chuck heads.

Пікірлер: 8

@tonyturnswood Жыл бұрын

You saved me some money! Great work again Mr. McDaniel! Appreciate you!

@woodworkingmcdanielstyle Жыл бұрын

Thanks Anthony! I appreciate the feedback and glad I could help.

@twinoaksfarm8088 9 ай бұрын

Try Rubber Chucky

@woodworkingmcdanielstyle 9 ай бұрын

Thank you. I’ll check them out.

@markfutato7547 21 күн бұрын

I just bought the system and at best I get 6” Hg. Not nearly enough vacuum. Suggestions?

@woodworkingmcdanielstyle 21 күн бұрын

Have you tried on more than one piece of wood? Some wood is so open grained that I sometimes get low vacuum until I wipe on some wood butter which fills the pores. I am assuming your air compressor is at 90 psi or more? If so I would try placing on something non porous like a dinner plate or cookie sheet. If you still get low numbers then I think it is defective and they should send you a replacement.

@markfutato7547 21 күн бұрын

@@woodworkingmcdanielstyle Thanks for the quick reply. If I do not have the line attached and place my finger on the nipple of the vacuum generator, I only get 6 Hg at that point, so I am thinking the generator is faulty. I appreciate you.

@woodworkingmcdanielstyle 21 күн бұрын

@markfutato7547 you are very welcome. Sorry you had a bad experience. Hopefully they replace it with no hassle for you. I have had mine for several years with no issues but I’m not sure if I got lucky or you were unlucky…