Excited to make some upgrades to my BMW! #carguy #mechanic #holleyperformance #lsswap EDGELEC 470 ohm Resistor 1/2w - a.co/d/cletvMh ICT Billet LS Alternator Connector - a.co/d/5txcUQJ
Пікірлер: 10
@GeoffyDunk9 ай бұрын
You got any questions with the Holley give me a shout. I’ve been through the whole thing now and setup some different settings in the ecu itself
@LyonRacing249 ай бұрын
Yeah I do have one or two
@WilloW00248 ай бұрын
Nice build! Which exhaust manifold are you using on the driver side?
@LyonRacing248 ай бұрын
Its from a C5 corvette. I did have to modify it some to fit, but it wasn't bad. Now i did make my own motor and transmission mounts.
@lazyfocus38747 ай бұрын
Where did u tap that red/white wire at?
@LyonRacing247 ай бұрын
The big red/ white goes straight to the battery
@lazyfocus38747 ай бұрын
@@LyonRacing24 no the one u have to tap into a 12v at ignition and cranking.
@LyonRacing247 ай бұрын
its in part 3 of the install I used the BMW ignition Key and wiring.@@lazyfocus3874
@lazyfocus38747 ай бұрын
@@LyonRacing24 ohhh ok got it. I ended up using the cruise control in the fuse box. Seemed to have power even wen cranking
@LyonRacing247 ай бұрын
@@lazyfocus3874 good deal buddy, I pulled every bit of wiring out of my car and re wired it only using what I needed.