Home-built jackstands
Рет қаралды 27,452
4 жыл бұрынCustom built stands I fabricated and welded for when I cut my frame on the caddy.
@victoryfirst2878 2 жыл бұрын
I will be making these in a week or two. Nice work too.
@jeffalvich9434 2 жыл бұрын
Those are very well built!!!! Much better than most any of the 3 ton jack stands commercially available!!!!! very nice job & very safe!!!!!!!!!!!!!! Just an FYI.... might also consider adding a bolt on larger base to them....typically you want about 3/4" base for each 1" of height.
@theweldor757 3 жыл бұрын
Good job brother ! I'm the same way . If you can built it yourself your way ahead a the game !
@dodgesportsman772 3 жыл бұрын
Holy crap!!! Those jacks could hold up a Building
@leandrofrancaniteroi744 2 жыл бұрын
Show de bola!
@romeo_alpha0176 3 жыл бұрын
Bad ass stands there. Would it be structurally compromised if there were holes drilled on the other side of the square tubing for finer height adjustment?
@bmfspeedshop4562 3 жыл бұрын
Yea I can't awnser that ... I mean I never fully trust any jack stands I prefer ramps, but I haven't made a set of them yet
@aldencorbin3126 3 жыл бұрын
a tip: watch movies at Flixzone. Been using them for watching lots of of movies recently.
@novasilas9306 3 жыл бұрын
@Alden Corbin yup, I've been using flixzone} for since november myself :)
@kenzomarkus4888 3 жыл бұрын
@Alden Corbin Yup, I have been using Flixzone} for months myself :D
@charlescolby45 3 жыл бұрын
@Alden Corbin yea, I've been watching on Flixzone} for since november myself :D
@Sacrificepain66 2 жыл бұрын
That’s right might as well make it yourself made in America
@georgeowen2083 Жыл бұрын
They look good other than the fact you have a flat top and don’t have any V groove or edges to help prevent slide off.
@bmfspeedshop4562 Жыл бұрын
Yea I was gonna run a bead on the edges but then I decided to leave it flat so they would all be the exact same height. I agree tho I did put some grinder cross hatch to make them better.