Рет қаралды 23,283
▶︎ ➡️ LEARN HOW TO SKATE: bit.ly/HOW_TO_SKATE
► what? DIY SKATE WHEELS?? yes, these are HOMEMADE SKATE WHEELS
90a urethane used for these wheels: www.smooth-on.com/products/pm...
Spray used for Mold release: www.smooth-on.com/product-lin...
Modified Pressure chamber, so that there is an open and close valve for the inlet and outlet on the top. Connect to a compressor and keep pressurized 70-80 psi for total cure time: www.harborfreight.com/2-1-2-h...
Convection oven that gives consistent heat and goes low enough for urethane cure-150 degrees F for 4 hours: www.amazon.com/gp/product/B07...
¼-20 .75” flat head screw used on the base of the mold to join the bearing plug to the base: www.mcmaster.com/92210A540/
► Buy the MASTERBLADE frames here:
bit.ly/MASTERBLADE
WATCH - KAREEM SHEHAB // THE MIND BEHIND MASTERBLADE FRAMES :
• Video
Follow Kareem Shehab & MasterBlade:
/ killakareem
/ masterbladeco
Join this channel and get access to exclusive content here:
bit.ly/JoinRicardoLino
100K, LETS GO ►🇬🇧bit.ly/wheeladdict ►🇵🇹bit.ly/wheeladdictPT
WHEELADDICT T-SHIRTS AND SKATES BUY HERE:
► www.wheeladdict.shop
Support this channel by using code "lino" at :
- www.bladeville.com
- www.hedonskate.com
Support The Lino Life:
- bit.ly/PatreonWheelAddict
Gear used to make my videos:
- bit.ly/LINOSGEAR
my Tik Tok: / ricardo.lino
my website: www.thelinolife.com
my Instagram: / ricardolino
my twitter: / realwheeladdict
my facebook: / ricardo.lino .
#wheeladdict #ricardolino #becauseitsfun #skating #inlineskating