You would be hell on wheels if you had a bigger shop... thanks it is a learning tool for most that are 1st timers
@thesnakeguy527410 ай бұрын
I had same exact thing happen to mine. I figured it out. It was the chain tensioner. Somehow it got stuck in closed position and I unlocked it. And it depressed. The guy I got it from. Had work done on it. I drove it maybe 4 times then it acted up and died and wouldn't crank back up. But got it in time and fixed the tensioner and retired the carb and it ru s like a champ. Hope this helps.
@Day12My10 ай бұрын
Isn’t there usually a reason that it gets out of time?? Something needs to be replaced or it’s going to happen again right?
@aubreyhayes211711 ай бұрын
So then did you thank the clutch off?
@mikesatvs74952 жыл бұрын
Thanks
@RidetheWings862 жыл бұрын
You are welcome!
@jamesjanzen9806 Жыл бұрын
Anyone know where the wires are for the fan. and how to wire them to a switch for the fan for the oil cooler. I’ve hade my 02 450 foreman for 2 years and dow’t think I’ve ever heard my fan turn on 😬
@danielcastro8012 Жыл бұрын
As long as you keep it running, air flow will hit the oil cooler therefore it won't need to activate the fans, i have a foreman 450 and a rincon 650 and the fans wont come on till maybe 40-50mins of hard driving
@GozonTheGonsarian Жыл бұрын
jump 12 volts to the fan wires to see if it works. if it works change your temp sensor its at the bottom rear of engine i think (mine is a 500). you can also pull the wire off the sensor and ground it to the frame with a switch inline. i would suggest changing the sensor though.
@GozonTheGonsarian Жыл бұрын
I have bought a few chinesium karbz. none of them have ever worked. don't buy them. sounds like you could use an O ring kit.
@bolambert64572 жыл бұрын
Gas ain't supposed to come out the throat of the carb...Timing or value too tight probably
@RidetheWings862 жыл бұрын
yes I figured it out. thank you
@Rickey_Ross2 жыл бұрын
@@RidetheWings86 what was it? I’m fighting a similar problem
@RidetheWings862 жыл бұрын
@@Rickey_Ross it was out of time.
@brendahall7483 Жыл бұрын
Well described; however, I would prefer to actually view the repair being made in its entirety. Telling me how to do it and then “bring you back when it’s done” is not nearly as effective as seeing it being done. Otherwise good video.
@RidetheWings86 Жыл бұрын
Due to life getting in the way. It has not been finished. Sorry. I have t touched it since this video.